-
Anonymous users2024-01-23Induction soap dispenser is generally divided into dripping, foaming, or atomizing, the new machine needs to be inducted several times to see the weather conditions, sometimes dozens of times, or manual extrusion interference, the air in the discharge pipeline can be normal liquid, foam to consider whether the liquid is viscous, if it is too thick, you need to add water to dilute it to foam normally. Of course, the above premise is that the soap dispenser has normal power supply and normal induction, regardless of the FEEGOO brand or other manufacturers' brands.
-
Anonymous users2024-01-22There are too many reasons for this, the quality is poor, the mouth is blocked, or the weather is cold, it is frozen, or you don't unscrew the mouth, or what, there is no soap in it, anyway, it is the above possibilities, check them one by one.
-
Anonymous users2024-01-21Either the hand sanitizer is gone, the battery is dead, or the hand sanitizer you put in is too strong, so you can't go to Taobao and Jingdong customer service to ask.
There are many types of soap dispensers, in short, they are devices that put soap in it and can take out a little bit by pressing it with your hand.
In this case, it should be that the outlet is blocked, and you can check whether the outlet is blocked.
This should not have anything to do with the water heater, it should be a problem with the installation of the water pipe, or the water pipe is small, the span is too long, there is a cold space in the middle, or the hot water pipe is not smooth, which may lead to this phenomenon. It is recommended to do a good job of insulating the hot water pipe, which may be better.
The heater heater motor does not rotate, most likely because the bearing of the fan motor lacks lubricating oil"Hold the shaft"The general fan motor adopts powder metallurgy bearings, and can only use lubricating oil with a lower concentration (such as sewing machine oil), and the fan bearing can only be used to fill the fan bearing with lubricating oil through the oil filling hole of the bearing end cover every year in order to work normally. >>>More
The water pressure is low and the flow is too small.
Open the bathroom valve wider, and clean the shower. >>>More