Can I use the light cord on the top of the balcony as the power cord when installing an electric dry

The light line has a switch control, if the switch is disconnected, the light is not on, and the electric drying rack has no electricity. In this way, you have to turn on the lights during the day to lift the drying rack, which is inconvenient, so you have to pull the fire wire from the front of the light switch, and pull the zero line.

The installation method of the electric drying rack is:

1. Confirm that the top surface of the installation is level, flat, solid and ensure that there will be no water seepage and water leakage on the top wall at any time; Confirm that the voltage of the input power supply is between 180-220V 50Hz, the power supply can be turned off at any time, and there must be a ground wire.

2. The position of the hole should be measured, and then the hole should be punched, and the hanger should be fixed to the wall with expansion screws after the hole is punched to increase the safety of the drying rack.

3. Install the drying rack box on the hanger, and there are corresponding interfaces at both ends of the drying rack box.

4. Install the bracket group, directly connect and fix the folding arm with the fixing bolt, fix the fixing bolt on the connecting hole of the folding arm on the other side, install the fixing bolt, pass the wire rope through the bolt hole, and then tighten it with the bolt screw, and the same operation on the other side, pass the wire rope through the bolt hole, and then tighten it with the bolt screw.

5. Then connect the power supply, for safety reasons, be sure to check whether the power has been turned off.

6. Assemble the drying rod accessories, put the drying rod into the half-mouth ring at both ends of the lifting frame, and after the drying rod is put into the ring at both ends of the lifting frame, clamp the drying rod with a pipe clamp and install the pipe clamp screw.

7. Finally, carry out the remote control test and install the remote control base.

You can't use the light line on the top of the balcony as a power cord for an electric drying rack.

The light line is controlled by a switch, and if the switch is disconnected, the light will not be lit, and the electric drying rack will not be able to be powered on.

If the light line on the top of the balcony is used as its power cord, the light will always be on when the electric drying rack is used during the day, which is not conducive to energy conservation and emission reduction.

Therefore, if you have to choose the light line on the top of the balcony, you need to pay attention to the use of the live wire, and you need to pull the neutral wire separately.

To install Mrs. Hans electric drying rack, you need to check the cracked slag of the power shed, confirm that it is 220V 50Hz, the power supply can be quietly turned off at any time, the source must be connected to the ground wire and reliably grounded, do not use wires smaller than the square.

Can I use the light cord on the top of the balcony as the power cord when installing an electric drying rack?

Hello dear, can't oh <>

It is not recommended to use the cord of the balcony light as the power cord of the electric drying rack. If the balcony light line is used as the power cord of the electric drying rack, when the balcony light is turned on and off, the electric fiber drying rack will not be able to be electrified, otherwise the electric drying rack will be used during the day, and the light needs to be always on, which is not conducive to energy conservation and emission reduction. If you need to use the light line on the top of the balcony, you need to pay attention to the use of the live wire, and you need to pull the neutral wire separately.