How to decorate the bathroom, how to apply the waterproof layer? In addition to the floor, do you ne

The standard for bathroom walls is meter high.

If your bathroom does not include a bath, it is enough to make 30 cm waterproofing on the wall; If bathing is included, the waterproofing of the wall of the bathing part should be made meters high. The ground must be waterproof!

What is needed, mainly the shower room, the wall waterproofing is best done 1 meter high.

Decorate the bathroom, the waterproof layer has a standard ground with a slope of 1 3 degrees. The lowest point is the floor drain. The waterproofing layer of the two walls of the bathing place should be made meters high. If your family is tall, you can ask to be taller. The rest of the wall waterproofing layer is 500 mm high.

The requirements for the wall shower area must be meters or more. If there is a shower room, just make the wall of the shower room waterproof. Other places can not be done, in short, as long as there is contact with water, it must be waterproof. The ground is done normally.

THE WATERPROOF LAYER SHOULD EXTEND FROM THE GROUND TO THE WALL, 250MM HIGHER THAN THE GROUND, AND THE HEIGHT OF THE WATERPROOF LAYER ON THE WALL OF THE BATHROOM NEAR THE SHOWER HEAD SHALL NOT BE LESS THAN 1800MM; THE WATERPROOF LAYER OF THE COATING FILM IS EVENLY BRUSHED, THE GENERAL THICKNESS SHALL NOT BE LESS THAN 1 5MM, THE WATERPROOF SURFACE OF THE COATING FILM IS NOT BLISTERING, NOT FLOWING, SMOOTH AND CONVEX, AND THE JOINTS OF PIPE FITTINGS, SANITARY WARE FEET, FLOOR DRAINS, AND DRAINAGE OUTLETS ARE TIGHT, AND THE END IS SMOOTH AND DOES NOT LEAK After the waterproof project is completed, it is necessary to do a 24-hour water storage experiment.

The wall needs to be sprayed to the height of the water, about 1800 is the best, and the waterproof three layers are the best

The bathroom is waterproof, and the surrounding walls need to be painted at a height of not less than 30 cm; If there is a shower, the height of the waterproof paint applied on the installation of the shower faucet and the adjacent wall should not be less than 150 cm, preferably about 180 cm.

After the waterproofing is done, a closed water test should be done. It is to put the water on the floor of the bathroom, so that the ground is completely submerged in water about 3 4 cm, and set a fixed elevation (horizontal plane); After 24 hours, if the water level is below the set elevation, it means that there is a water seepage problem on the ground, that is, the waterproofing is not done well. In this way, it is necessary to re-do the waterproofing.

If the bathroom waterproof paint is brushed and tiled on it, it should be painted with cement-based waterproof materials. The cement-based waterproofing material can be bonded to the cement base layer, its adhesion is very good, and it will not shell after pasting the tile. Other (non-cementitious) waterproofing materials are prone to shelling, which can cause wall tiles to fall off.

Why do you need to be waterproof in the toilet and bathroom?

This mainly takes into account the safety of the waterproofing of the toilet and the overall waterproofing effect. Generally, the shower or sprinkler head is installed at a high or so bottom if the waterproof is done. Long-term spraying causes water to soak the wall and mildew the wall.

Problems such as peeling of paint or bricks for wall decoration. Thus it does not have the effect of water iris. In principle, it is enough to make meters for non-shower walls, but in order to strengthen the waterproofing effect, we will uniformly achieve meter height.

And the cost does not increase much, in addition, for the light wall and self-built light wall of the toilet and bathroom renovation, it is recommended that the waterproof height should be at the top.