How to paste small toilet tiles

Tools Raw materials.

Tile glue serrated trowel.

Method steps.

1. Preparing for decoration will more or less involve the renovation of the wall, and the workers need to finish the project of the powder in the early stage of decoration to ensure that the renovation wall can be fully dried. 2. Material selection.

Different materials can be selected for pasting according to the actual economic situation.

3. Ingredients: Add water to the powdered binder one by one, and mix the ratio of 1 part water + 3 parts binder.

4. Stir and mix the binder slurry until it is lubricated evenly, and there is no obvious lump or paste knot, and the construction slurry after stirring will stand for 5-10 minutes, and then stir slightly for 1-2 minutes, and then it can be used.

5. Grass-roots treatment.

All kinds of dirt on the wall should be cleaned up, and the site should be cleaned, especially in the foothills.

6 batches of walls and wall leveling.

Use a trowel to batch the wall first, and then level it with cement slurry. This process is very important to ensure that the base is flat and prevent hollowing after pasting.

7. Brush with waterproof paint.

The wall should be brushed with waterproof paint to prevent soaking in water after pasting, and the general height is not less than meters, and it will be slightly higher when brushing.

8. Find the horizontal baseline.

According to the requirements of the design paving pattern, determine the brick arrangement scheme, and use the ink fountain to play the line to reduce the construction loss.

9. Adhesive on the wall.

Scrape the freshly mixed binder slurry evenly onto the wall.

10. Groove with a sawtooth trowel This point is a point that distinguishes the old process from the old process at present, the binder slurry is used to wipe the surface of the base layer to be paved, and the strip slurry after combing by the sawtooth trowel is full and continuous.

11. The tile on the wall is laid flat on the adhesive slurry base layer after pre-cleaning, and the tile is paved flat with a rubber hammer. During the construction process, the tile can be rotated in a small increment to make the slurry fully contact with the back of the tile. Experts recommend that the tiles that have been laid on the base layer should be removed randomly for inspection.

Make sure that the slurry is in full contact with the back of the tile.

12. Adjust the size of the joints according to the size of the tiles, and reserve the corresponding size of the gap between the bricks and the bricks for caulking. It can be fixed with a toothpick, etc., and the adhesive has a certain degree of adjustability, and the size of the seam can be adjusted.

13. After the horizontal inspection tile is paved, the worker will use a professional measuring instrument to check the flatness of the tile after pasting to ensure that the final effect satisfies the customer.

14. The finished product protects the paved tiles must have protective measures, which can be protected with films.