-
Anonymous users2024-01-23The reason why there are three holes is because there is more than one type of mixing faucet, there are three independent connections combined, such as the hole in the middle is installed with the water outlet, the holes on both sides are installed with cold water switches, hot water switches, the link of the mixed water is combined together with a connecting pipe under the basin, some basin drains have a movable cover, the cover is connected with a connecting rod, the connecting rod is directly behind the faucet, and the pull-out type, this pull rod is installed in the hole in the middle, so it is necessary to make a three-hole basin, a general-purpose basin, As for the spill (the overflow, which is the round hole in the façade in the recess on the inside of the basin), that is the real overflow.
-
Anonymous users2024-01-22If there are three large holes, there are generally hot and cold water switches on the left and right, and a water tap in the middle. If there are two large holes and a small hole, the two large holes are the hot and cold water (left and right turning) switch and the water tap, and the small hole is the tie rod hole where the water is blocked.
-
Anonymous users2024-01-21Installation of hot and cold water pipes for quasi-recuperation work.
1. There are hot and cold water pipes in the general sanitary room, and it is best for us to draw the corresponding drawings before construction.
2. The spacing between the hot and cold pipes should not be too close, and at the same time, the bathroom water pipes are all from the roof, which can reduce the number of man-made damage.
Rate. 3. The interface and outlet of the hot and cold pipes must be parallel, generally the left is hot, and the right is the cold water pipe. The wiring of the pipe should be designed in such a way as to avoid bending and as far away from the circuit as possible.
4. Finally, the position and slope of the pipe clamp should also meet the requirements, and each valve should be installed smoothly to facilitate future use and maintenance.
There are different installation methods for various types, taking the more common wall-mounted and floor-mounted types as examples >>>More
Hello, the advice for you is 1Turn on the faucet switch on the top of the basin and rotate it to the direction of hot water; 2.In the case that the orange line of the water supply pipe is normal and the electric water heater is working normally, if there is no water flowing out of the faucet, the water inlet switch belonging to the electric water heater is not opened, and the water inlet switch can be turned on. >>>More
1.There are three main types of wash basins: wall-mounted type, column type and desktop type. If you want to save space, you can choose the wall-mounted type, that is, the washbasin installed against the wall, the pipeline is exposed, and it is fixed by screws hanging on the wall, which must require the fixed wall to be a load-bearing wall. >>>More
There are different installation methods for various types, taking the more common wall-mounted and floor-mounted types as examples >>>More
Is it caused by sand in the filter of the cold faucet?