-
Anonymous users2024-01-23As long as the toilet lid will have installation screws, now the design is more ingenious, take a closer look at what should be, most of the toilet lid on both sides of the back side of the seat will have a position to open the lid, fixing screws are installed inside, look for it, it is best to have a picture to reply accurately.
-
Anonymous users2024-01-22rapaima, a mammoth f
Bucket lid selection one Nowadays, the length of the toilet lid is basically more than 50 cm, but many toilet seats have reached about 52-58 cm, and the length of the seat ring corresponding to the size and length of the toilet lid is basically about 30 cm, and when we buy the toilet cover, we can measure the tip of the toilet bowl to the front of the water tank along the center line of the toilet.
<> generally, there are two plastic screws on the left and right sides of the toilet, first remove one side, and then screw the white screw cap by hand, if it is too tight, you can borrow pliers and other tools to clamp it and unscrew it, and then disassemble the other side. Unscrew the screw cap, pick up the toilet lid with both hands, lift it up, the toilet lid will be removed, pay attention when tightening the screw cap, it is unscrewed to the right, and when lifting the toilet lid up, you should be light, and be careful to prevent the screw and empty wire nails from being stuck.
It is universal, and there are two sizes, which can be selected according to the size of the toilet.
You can go to the local bathroom market, match one, and measure your bad size before going.
The customer service said that the shaft behind the lid was broken, and it was replaced by a 25, a pair of 50, and the door-to-door fee was 50