-
Anonymous users2024-01-23If you talk about floor drains, clean up the sediment at the drain storage area, and the water storage is enough, try it.
-
Anonymous users2024-01-22Find it on the floor drain: change the odor-proof floor drain.
It can be determined that the trap leakage of the toilet squatting bend is leaking, then the trap belongs to the different-layer drainage, because the trap of the same layer drainage is buried in the caisson, even if the trap leaks water, it is not visible, and the manifestation can only be that the odor in the bathroom is heavier. For the leakage of the trap of heterogeneous drainage, it can be seen very intuitively in the next layer. This can be solved as follows. >>>More
Look at which part, if it is a washbasin drain, you can install an S bend on it, if it is a toilet drain, just install a toilet directly, it comes with a water trap, and then there is a hole you see is broken, three or two yuan of play, is the screw is open or the rubber ring below is broken, and it doesn't take a few dollars, it is estimated that the screw is loose, you can go on it, don't be too serious, I hope my answer can help you.
First, you can see if there is an anti-odor floor drain installed in the bathroom. >>>More
It doesn't matter, as long as it's that, and it conforms to the principle of the connector.
This problem is a bit complicated, it depends on the installation of the overall drainage system, and the actual situation is good to explain, if the anti-bend does not leak, the indoor temperature is normal, the only explanation is that there is an unreasonable design in the overall drainage system, and the air in the system can not be discharged when using water in other places, causing the air in the pipeline to swim around (siphon or air surge, etc.), that is, when the water is used in other positions, there will be a sound at the position of the anti-bend, and the water level moves the phenomenon, which destroys the water seal height of the anti-bend.