The toilet flushes the urinal and runs out

Updated on Toilet 2024-02-27
2 answers
  1. Anonymous users2024-01-23

    Summary. This is because the inner wall of the toilet water trap elbow is damaged, and the water is leaking out of the damaged place. In this case, it is better to replace the toilet. If you can see the damage, you can repair it with special glue or glass clay.

    This is a crack in the toilet water trap and the inner wall of the bridge pipe is damaged, and the water is leaked out of the damaged place. In this situation, it is best to replace the trapped rock toilet. If you can see the damage, you can repair it with special glue or glass clay.

    Theoretically, there is no stateable and can row sails with all the flushes, the toilet flush starts with pressure, and the middle and rear stages are siphon Xingqingli, the premise is to maintain the vacuum, and the vacuum destroys the siphon before the end is gone, and there will be some water left, so as to ensure the existence of the S bend water seal and block the odor.

  2. Anonymous users2024-01-22

    Theoretically, it is not possible to drain all the flushes, the toilet flush starts with pressure, and the middle and later stages are the siphon force, provided that the vacuum is maintained, and the vacuum destroys the siphon force before the end, and there will be some water left, so as to ensure the existence of the S bend water seal and block the odor.

Related questions
5 answers2024-02-27

1. It is because the thimble in the water supply valve may not be able to go up, and there is another possibility that the filter screen of the water supply valve is blocked. If it is blocked, you can remove it and clean it yourself. If the thimble is broken, you will have to replace it with a set of water pieces. >>>More

7 answers2024-02-27

What to do if the toilet tank keeps running water.

2 answers2024-02-27

It is very likely that the toilet is broken. It is recommended to take it apart and take a look.

5 answers2024-02-27

This is because the plug did not reset with the flow of water when you flushed the toilet last time, you only need to press the flush button again with your hand, and hear the sound of popping in the water tank is the plug reset, and you will not have this situation again when you flush the water in time, please adopt.

2 answers2024-02-27

Bathroom master analysis:

Step 1: Make sure the toilet close-off valve is in the closed position. >>>More