-
Anonymous users2024-01-231. Square aluminum gusset: You can use a very thin blade tip to gently insert the corner gap of the gusset plate, try to move it down, dial a little bit, dial the other diagonal side of the gusset plate in the same way, and then dial the diagonal edge of the other pair of sides, repeat several times, you can disassemble the square aluminum gusset.
2. Square aluminum gusset: The removal of the square aluminum gusset can also be pulled down from the edge with a suction cup, or pry down from the edge with a small flathead screwdriver.
3. Long aluminum buckle plate: The long aluminum buckle plate can be removed from the last board, and then removed in turn.
4. Long aluminum buckle plate: The long single buckle aluminum buckle plate can be pry down the edge of the single piece with a small slotted screwdriver, and the single piece of the buckle plate can be removed individually.
-
Anonymous users2024-01-22Hello answer, there are some strip-shaped ceiling panels, inserted along its gaps, with a few strokes with a wallpaper knife. Find its buckle position first, and then knock down, you can knock the middle first, and then knock on both sides, you can remove the ceiling buckle plate.
If it is a PVC ceiling gusset, remove the glass glue with a knife first, and then use a screwdriver to gently pry in the gap between the penultimate block and the first block, and then this piece of PVC board can be removed.
Question: Is it easy to attach it when it is removed?
Ask a good question, thank you.
How to dismantle the aluminum gusset ceiling:
1. When we decorate again, we may want to change a ceiling plate when we will disassemble the aluminum buckle plate, and if you want to remove it, you should know how to go up the equipment and how to equip the aluminum buckle plate. >>>More
With metal, adjust it slightly.
Drywall is sawed off with a cutter or saw.
If it is an embedded integrated lamp with the same specifications as the ceiling, it can be removed with a special suction cup or straightened with a paper clip, and it can be plugged into a pry from the crack of the plate, this kind of lamp is very thin, if it is a lamp installed separately, there is a change cone to gently pry the cover plate seam, and the lampshade can be removed.
Downlights basically have two circlips, which are "fixed" on the top surface by those two circlips. When disassembling, pull the edge of the downlight down a little by hand, and then turn the circlip to the middle after seeing it, so that you can take the downlight downlight.