How to dismantle the aluminum gusset ceilingPrecautions for dismantling the aluminum gusset ceiling

How to dismantle the aluminum gusset ceiling:

1. When we decorate again, we may want to change a ceiling plate when we will disassemble the aluminum buckle plate, and if you want to remove it, you should know how to go up the equipment and how to equip the aluminum buckle plate.

2. The role of the aluminum gusset plate with good equipment.

3. Square aluminum buckle plate: If you want to start dismantling it yourself, you can first buy a suction cup, use the suction cup to stick to a corner of the square, and then pull the corner of the aluminum buckle plate hard, and the other three corners can be disassembled in the same way, so that the labor cost of dismantling can be effectively removed.

4. Strip aluminum gusset: the time and division of the equipment is pressed one by one, and after all, there will be a small slit of about centimeters. The wallpaper knife pierced along the gap, swiped back and forth a few times, found the direction of the clip, and then quietly pry down, first pry the base, pry the slight deformation of the two ends.

5. This kind of gusset is dismantled from the edge strip, and usually the edge banding strip and the tile will be fixed with glass glue, so the edge banding strip and the tile are cut between the demand. First of all, you must find a gusset plate that is finally installed, and then use a flat-head screwdriver or a thin long iron sheet to quietly cut a few knives along the glass glue, and then insert it into the gap of the edge sealing, quietly pry it hard, and then disassemble it from the edge in turn.

Precautions for dismantling aluminum gusset ceilings:

1. When the original ceiling decoration is removed, attention should be paid to removing and cleaning as much as possible, and the original ceiling decoration structure should not be preserved. In addition, it is necessary to remove the structure that carries the ceiling components such as booms and pendants in the original ceiling, which must be considered from the safety of the future.

2. When removing the power supply, the original circuit pipeline in the ceiling should be removed as much as possible, and then think about continuous use, because the original circuit in the ceiling has no application value.

3. When removing, we should think about the safety of the equipment and equipment in the original ceiling, many old houses in the last century have heating pipes in the ceiling, and some residences are air-conditioning systems, so as to prevent damage to the pipelines and equipment due to the removal of the pipeline.

4. When removing the original ceiling in the kitchen and cleaning room, it is necessary to prevent damage to the ventilation duct and flue.

Hello answer, there are some strip-shaped ceiling panels, inserted along its gaps, with a few strokes with a wallpaper knife. Find its buckle position first, and then knock down, you can knock the middle first, and then knock on both sides, you can remove the ceiling buckle plate.

If it is a PVC ceiling gusset, remove the glass glue with a knife first, and then use a screwdriver to gently pry in the gap between the penultimate block and the first block, and then this piece of PVC board can be removed.

Question: Is it easy to attach it when it is removed?

Ask a good question, thank you.