Workers insist on installing toilet sealing materials with putty without flanges, can it have been i

It's still okay to use putty, but if you use a flange, you will feel a little more stable, and the appearance will look more beautiful, but you should save a little money if you use putty.

The installation method is relatively simple now. The toilet bowl is connected and sealed with a so-called toilet flange ring (plasticine), and the bottom surface of the toilet bowl is sealed with silicone (silicone) sealant. When installing, the toilet must sit firmly on the ground, and it can be adjusted by padding, and must not be shaken, and then it can be glued and sealed.

The glass glue can be made of silicone sealant for kitchen and bathroom. When installing, it is necessary to ensure that the place where the glue is applied is clean and dry, so as to ensure that the sealant is firmly bonded.

The mouth of the sewage pipe should be level with the ground, neither high nor low. If the sewage nozzle is half a centimeter high, you have to see if there is enough gap between the sewage outlet and the sewage outlet you bought to accommodate the flange, otherwise the toilet will not be able to sit firmly on the ground, or the bottom of the toilet will have to be padded all around, and it is not easy to be very stable.

Rest assured to use, reasonable use of putty effect is very good.

If their skills are good enough, it's fine.

Yes, but the flange ring is a bit more professional.

2-1. Sanitary ware installation and construction requirements:

The sanitary ware should be unpacked and inspected in time to check whether it is intact. Whether the brand, specification and model meet the requirements of the contract configuration.

The basic requirements of sanitary ware installation: "flat, stable, firm and accurate" are well used, and the installation should be handled gently to prevent damage, and strong installation is strictly prohibited.

2-2. Installation process requirements for toilets:

The first line determines whether the toilet specifications are consistent with the distance between the pit, and takes the pit pipe mouth and the toilet sewage outlet as the center, and draws the position line of the base and the installation position of the foot bolts on the ground.

Use oil lime or the purchased "pit pipe viscose sealing ring" (commonly known as flange) to make the waterproof sealing around the pit pipe, and install a certain length of foot expansion bolts (more than two).

Apply silicone or lay a layer of putty at the position occupied by the base on the ground for sealing and adjusting the level of the toilet during installation, and use a spirit level to correct the levelness of the toilet: 2mm

The foot bolts on both sides of the toilet base can be slightly tightened, not too tight to prevent the base porcelain from cracking, and seal the base around the base and the foot bolts with mildew-proof white silicone, and cover the corresponding screw cover.