How do you install a flush toilet directly on a squatting toilet? Because it is difficult to change

Updated on Toilet 2024-02-24
5 answers
  1. Anonymous users2024-01-23

    The main thing is to see if the hole spacing between the PVC pipe against the wall of the squatting toilet is enough, and if it is enough, there is no problem.

  2. Anonymous users2024-01-22

    Originally, did you use tap water to turn on the switch directly to flush, but now change to a water tank to flush? Take a look at how big the flushing pipe is at the back, the original flushing pipe is surface-mounted, and it can be replaced, if the wall is buried, the wall must be destroyed to change, if the flushing pipe is broken, you have to chisel the back of the squatting stool, pay attention not to chisel waterproof.

  3. Anonymous users2024-01-21

    There should be nothing wrong with it, if there is a backwater bend in the squatting stool, it is best to use a straight toilet, and use a PVC pipe to connect the squatting entrance and the toilet outlet, so that the probability of being blocked will be relatively low.

  4. Anonymous users2024-01-20

    Most of the squatting toilets commonly used at home are in the front of the drain, that is, the hole is in the back, because the squatting toilet is still some distance from the wall, so the difference between the squatting toilet and the toilet is relatively large, and most of the toilets are 305

    The best way is also the most troublesome: dig up the ground and redo the drainage and waterproofing If you want to squat the toilet and not move it It seems impossible to install the toilet directly on it If you change the toilet just for the convenience of the elderly It is recommended to buy a stool like a toilet lid.

  5. Anonymous users2024-01-19

    You can't remove the counter first, and you need to choose a better flush toilet.

Related questions
3 answers2024-02-24

A flush toilet consists of the following main parts: inlet pipe, outlet pipe, seepage pipe, plug (inlet and outlet), float, drain knob and lever. Be sure to understand the role of each of the above components in the work. >>>More

1 answers2024-02-24

How do you unclog a flush toilet? Toilet blockage is generally a blockage at the toilet trap, and the best and easiest way is... >>>More

1 answers2024-02-24

At present, there are three standards for the installation size of flush toilets in China: 200 mm, 300 mm, and 400 mm. 300 mm is the majority.

2 answers2024-02-24

The squat toilet is changed to a flush toilet, and if the waterproof is not burned after the change, it will cause water leakage downstairs. To change the rock movement, it is necessary to know that Duan Yu needs to change the water pipe, to raise the water pipe to the plane level of the floor tiles, to open the ground for maintenance, and to do a good job of waterproofing around the pipe again.

9 answers2024-02-24

Demonstrate it a few times, then report it, pose it, and then give it a reward for eating, and then let it go up on its own, if it doesn't go up, you do the above process a few times, which requires a lot of patience.