Gas water heater kitchen faucets can normally produce cold water and boiling hot water, but bathroom

The gas water heater is water-controlled and has a minimum water flow requirement, which is not met, and the water heater cannot release gas and turn on the igniter, and cannot be used.

It is recommended to check the water output of the hot water faucet, if it is small, it may be a problem caused by insufficient water flow.

The cold water is normal, the hot water output is small, you should consider why the original hot water is large, and now the hot water is small, the reason is that the scale deposit is more original, the problem of blocking the pipeline, the water flow rate does not meet the conditions, and the water heater can not be ignited.

There are many reasons why gas water heaters are not good for ignition, and any component damage of water, gas, and electricity will cause the water heater to fail to ignite. In fact, in many cases, the reason why the fire cannot be ignited is because the hot water pipeline is blocked due to the scaling of the waterway, resulting in a large back pressure of the waterway flow, which is large to a certain extent, and the water-gas linkage device will think that the hot water faucet has been closed and the gas channel is closed, and there is no gas, of course, it cannot be ignited.

It is recommended to clean and descale immediately, you can buy a set of gas water heater without removing the scale device online, use it to inject descaling agent into the water heater to clean the inside of the water heater and the inside of the hot water pipeline, the operation is simple and convenient, and it can be cleaned regularly after use, when this problem can be avoided again.