-
Anonymous users2024-01-23It's the gap in that, it's the window or the frame. The window may not be vertically inclined enough, adjust it, and there is a gap in the frame to beat the foaming agent.
-
Anonymous users2024-01-22Stuffing a circle of plastic foam should do the trick. You can also plug the surface brick with a suitable thickness, or a wooden square, and the appropriate length should be fine. In my case, I will choose a long wooden square, which is more convenient.
-
Anonymous users2024-01-21Look at the picture has not pasted the window sill brick or install the window sill board, the treatment methods have the following points: 1. Use polyurethane foam to foam the four sides of the balcony in place, do not be transparent, do the window cover covering, the lower window sill can be used as a stone window sill board, and the inner and outer frames of the window are glued after construction to increase the air tightness of the window.
-
Anonymous users2024-01-20This is your mistake in command when decorating, if you first seal the balcony and then paste the tiles, there will be no seams, now you can only find a bricklayer master to lay bricks and repair tiles.
-
Anonymous users2024-01-19If you want to be beautiful, lay a brick on the "window sill" and cover it.
-
Anonymous users2024-01-18It can be supplemented with glass glue or foam glue.
1.If there is a leak at the water outlet, remove the gland bolt and replace it with a new gasket. >>>More
There is a way to completely eradicate this problem after the solid wood floor is paved, which is to re-fasten the floor and reinstall the floor. >>>More
If you want to completely solve this problem, you should reinstall the floor, so that you can solve this problem, after the solid wood floor is laid, if you step on a foot somewhere and then step on it, continue to think, it must be that the wooden mortise and the floor wooden tenon is not fixed, if the wooden tenon material is too soft and not difficult, it will also be pulled up by the ground dragon to cause the floor to have a sound, so re-laying is the best way.
1. Scrape the width of the crack between the cabinet and the wall with a putty knife, and scrape it into a figure-eight shape, with a wide outer width and narrow inside. 2. Use dry powder gypsum blocks to plug the gaps, the filling depth is not less than 3040mm, do not fill with the wall, brush 108 glue lower than the wall and paste glass cloth or kraft paper strips. 4. Scrape 821 putty 23 times and smooth the original wall, and polish it with sandpaper after drying. >>>More
If there is water leakage in the tile gap, make waterproof coating on the surface of the tile, which is not a better way to solve the problem of water leakage in the tile gap. Do waterproof coating on the tile, can not completely solve the problem of water leakage in the tile gap, the waterproof coating on the tile gap is not real, and there will be water leakage, so that the maintenance cost is wasted, there is no need to do waterproofing on the surface of the tile, I think there is no such idea, even if the tile surface is waterproof coating, after stepping on the wear and tear of the water leakage, the waterproof coating on the surface of the tile has no way to deal with it, and it is a very difficult thing to completely shovel down the waterproof coating on the tile. >>>More