-
Anonymous users2024-01-23Wood floor moisture-proof mat function.
The main function of the wood floor moisture-proof mat is moisture-proof and warm-proof, because the moisture-proof mat is waterproof, it can play the role of moisture insulation.
The moisture-proof mat of wood floor is the partition between the floor and the ground, which is laid close to the ground, and mainly plays the role of moisture-proof, protecting the floor, increasing elasticity and ground leveling.
Wood flooring moisture pads don't need to be too thick.
When laying laminate flooring, it should be noted that the floor mat is not as thick as possible, too thick floor mat has a lot of room for maneuver, and the elasticity will make the floor joints crack, and even cause the tenon to break.
If the floor mat is too thin, the effect of moisture-proof and cushioning is relatively weakened, the elasticity is poor, and it cannot play the due leveling role, and the foot feeling is not good.
Expansion joints should be reserved for the moisture-proof mat of the wooden floor.
In order to avoid the moisture on the wall from spreading to the wooden floor, when laying the moisture-proof mat, it is not only necessary to cover the entire wooden keel, but also to leave the moisture-proof mat along the corner of the wall for about 10CM.
At the same time, there should also be an 8-12CM expansion joint between the wooden floor and the wall, if it is too close, the floor is easy to arch after expansion.
-
Anonymous users2024-01-22Lacquered hardwood floors. Use nails to hit the four sides of the board, the number of nails on the long side is 4, and the short side is two, more or less. It is forbidden to use glue for the laying of lacquered solid wood floors (except for all-purpose glue, but it may not be used). Same as above for the gap in the surrounding walls.
Sweep the paint clean, especially without grit! This is because these sand grains can cause a lot of wear on the paint surface.
Install and paint the baseboard (lacquered hardwood floors do not need to be repainted).
Precautions: Moisture-proof film can be added under the floor. There are two advantages to this approach:
Since the paint board is not grindable, the moisture-proof film has the effect of adjusting the ground level. It can increase the moisture resistance of hardwood flooring. There are drawbacks to this approach:
It is not conducive to the ventilation of the bottom plate, and it will cause the bottom plate to appear moldy for a long time.
Process effectiveness: This construction method was first adopted and constructed in 1998, and there has been no arching or deformation on the ground so far.
First of all, I am making flooring, solid wood flooring is the first to the more environmentally friendly floor, itself environmental protection is not wrong, but if the accessories in the morning secondary pollution, it is better to buy laminate flooring or multi-layer composite flooring or other directly, as far as the 9-layer board is concerned, since it is 9 layers in the raw materials must be glued to make the board combined through hot or cold pressing pressed out, in fact, the glue in the middle is close to the source of pollution, Keel solid wood floor must be done, but the 9-layer board, you can save it, don't install the underground, or your solid wood floor spends so much money in vain, it is better to buy multi-layer wooden door composite panels directly and cheaper, we sometimes pay attention to pollution when decorating, yes, but often many things on the surface are very polluted, but the accessories used are far beyond the standard, which is troubled by the home bag, in addition, you remember a little bit of any wood material furniture or siding as long as it is not a log must have glue inside, glue means pollution, Some of the furniture looks like logs, including your doors, tables, cabinets, kitchen cabinets, etc., in fact, a lot of them are just a layer of wood grain paper on the skin and then painted. If you want to pollute less, the 9 layers of boards under you are finally omitted, don't install the bottom.
Home decoration is not accepted by any acceptance, tooling has acceptance, generally good ground dragon Party A will come to accept once, mainly to see whether the materials are in strict accordance with the contract, such as the specifications of the wood or something, and then whether the dragon is firm. Then, after completion, the main thing is to check whether there is any abnormal sound, and whether the horizontal error of the entire site is within the allowable range, in fact, it is mainly to go through the motions. The so-called acceptance is HC, you know!
Installation requirements for solid wood flooring: it is strictly forbidden to use glue. That's because of the installation of solid wood flooring, he has quite high requirements for the floor, and only by making the keel can the requirements be met. Also nail it with a special nail for solid wood flooring! Otherwise there will be a rattle on the floor.
If it is installed with the keel method, there is no need for additional leveling, and the keel itself can be leveled. >>>More
1. The pavement scheme should be constant.
For each stadium, or theater stage, what materials to pave, and how to pave, are determined according to the actual parameters of the sports venue and the investment budget. Therefore, once the sports wood floor paving scheme is decided, it should not be changed easily. >>>More