How to install a water heater socket in the bathroom. Where is it appropriate to install.

1. First of all, it must be equipped with an independent three-eye fixed socket, and the circuit is a special branch circuit for electric water heaters, such as mobile wiring boards, sockets with switches, non-independent sockets, aging sockets, and loose sockets. Don't use it! These can cause hot plugs, sockets, and wiring, and in serious cases, it may be a fire!

2. Depi selects the matching wire diameter and connection method, and the electric water heater with different power must match the corresponding wire diameter and power supply connection mode.

Power Minimum wire diameter (mm) Power connection type Socket or air opening specifications.

20000W and below Independent fixed socket 10A socket.

2500W independent fixed socket 16A socket.

3000W independent fixed socket 16A socket.

3800W 4 Air Switch C25 Air Open.

4000W 4 Air Switch C25 Air Open.

5000W 4 Air Switch C32 Air Open.

6000W 6 Air Switch C40 Air Open.

Some people may not quite understand, let me give you an example! If you buy a Smith EWH-E10 electric water heater with a power of 3000W, then you need to be equipped with a 16A socket with the smallest wire diameter.

Please call me Lei Feng!!

THE WATER HEATER SOCKET IN THE BATHROOM NEEDS TO BE INSTALLED 30CM AWAY FROM THE WATER HEATER. It is more suitable to install more than one meter above the ground.

Requirements for installing electric water heater sockets in the bathroom: 1. Within 1 meter around the electric water heater; 2. The height from the ground shall not be less than meters; 3. The socket must use a splash-proof (waterproof) three-eye socket; 4. The electric water heater socket branch must be equipped with a leakage switch of no more than 30 mA seconds; 5. The socket branch of the electric water heater should be a copper wire not less than less than a square millimeter; 6. The branch of the socket of the electric water heater should adopt TN-S protection system, and the PE wire should be directly to the socket. OK！

Enough is enough!!

Install it out of water!

In the above position, do not install above the basin, behind the door, opposite the shower, and in the place where the bath towel holder is installed. 4mm square copper wire should be used, and there must be a ground wire. Pack a waterproof box.

Look at where the water heater is pressed and install the socket next to it. Consider the size of your water heater. The socket should be waterproof.

The socket is installed in the gusset and a wall switch is designed on the wall to control the socket.