-
Anonymous users2024-01-23Common causes of toilet flushing weakness:
1. The side handle chain of the side press and side wrench toilet is long, which causes the water stop pad to stop the water quickly, although it has action. Solution: Please shorten it to the appropriate level.
Or the top press bar of the top press toilet is low, resulting in the water stop pad moving but quickly stopping the water. Solution: Open the water tank cover, reverse, loosen the pressure rod nut, and adjust the length of the pressure bar to the appropriate one.
Second, the water level of the inlet valve is low, resulting in weak water outlet.
The solution is to remove the inlet valve and remove the inlet valve buckle. Turn the inlet valve body counterclockwise. Then increase the height of the body accordingly.
Then rotate the inlet valve body clockwise and attach the buckle. Finally, install the inlet valve. Connect the filter and water inlet pipe, and the fault can be eliminated.
I read it online and hope it helps. If you live in a residential building, it is estimated that the floor you live in is relatively low, when the upstairs sewage volume is relatively large, more than the sewage discharge capacity of the sewage pipe, the sewage pipe will form a full flow state, if there is no special ventilation pipe, then you can imagine a section of the pipeline in the water column due to gravity downward movement, like a bullet in the chamber of the gun, squeeze the air down, at this time the gas or sewage in the pipe will be squeezed into the toilet to form backwater, or some biogas in the sewage pipe is formed, this will also occur. >>>More
The sprinkler head is distributed according to the indoor layout, the wire mesh belongs to the grille ceiling, and the sprinkler head can be set to spray up.
The nozzle is self-cleaning before and after use.
After the nozzle is cleaned with live water, the spray rod is disinfected with antibacterial disinfection in the disinfection chamber. >>>More
The main thing is that the sound insulation of the house is not good, but you can wrap the pipes with sound insulation materials, so that the effect can be much better.
Generally, the flush toilet will have a separate inlet valve, which you can find by following the pipe. Otherwise, you should close the main gate first, repair it and then open it.