-
Anonymous users2024-01-23Waterproofing should be brushed with several more layers, and the waterproof coating inside is two-component. One part is slurry and one part is powdered. A brown brush like a brush, and a wooden stick for stirring is also prepared.
Before brushing waterproofing, the walls and floors should be clean and free of open water. Probably check it, it's ready to be brushed. When brushing waterproof, use the middle part of the bristles to brush so that the brush is even.
Do not use the tip of the brush brush, one is uneven brushing, and the other is easy to fly to other places when encountering uneven convex and uneven brushes. In addition, if the first time is waterproof, if the first time is horizontal, the second time is vertical. Vice versa.
The purpose is to brush evenly and tightly. After the first brush, wait for it to dry before brushing the second time. It is said that there is a secret to waterproofing in the waterproof world, called "the first time is like tofu brain, and the second time is like milk".
This second pass is finished, and the difference from the first time is really big. If you use white waterproof paint, it really feels like tofu brain and milk. During the brushing process, be careful not to let the waterproof paint get on your hands and clothes, otherwise it will be difficult to wash off.
Two coatings for waterproofing toilets.
Nowadays, the materials used for waterproofing are generally paints, and asphalt-based waterproofing coatings are basically not used. Here are two coatings commonly used for waterproofing in the bathroom. >>>More
1. The waterproofing of the kitchen floor should first be swept flat with cement mortar, and then brushed with flexible waterproof materials. The waterproof layer on the ground is brushed three times in order to better achieve the waterproof effect. >>>More
Not feasible, it needs to be painted twice.
Bathroom waterproofing process: >>>More
Yes, latex paint is waterproof, but the bathroom must be isolated, the interior wall latex paint can be scrubbed, can not be washed directly with a large amount of water, if the exterior wall can be water-resistant, but not as good as the interior wall latex paint, more rough. In addition, as long as it is latex paint, it is waterproof, and if it can't be watered, is it still called latex paint? That's called Big White.
The cement wall of the bathroom of the blank room can be directly brushed with waterproof coating; However, the selection of materials can only be water-based materials, such as JS polymer coatings, at least 2 times. Oily materials such as 911 polyurethane series are not bad, the key is that the surface is relatively smooth after filming, and the later decoration tiles are easy to stick and fall off; Bathroom wall waterproofing is also very critical, many people think that there is no need to do, (the old house basically did not do) I suggest that the bath has to be done on both sides of the bath bomb, decorated, the water in the bath will wash the wall in daily life and cause leakage There are too many cases; There are not a lot of materials and labor, so please refer to my suggestions!