What are the common connection methods of panel furniture

Now all the panel furniture sold in the furniture store is "three-in-one" connection, and the "three-in-one" connection method has a lot to do with the factory production and sales links, and the first problem is transportation, followed by installation.

We are in the production of panel furniture with "screws, log tenon, corner code" is feasible, whether it is from the beauty, firmness is not in the "three-in-one" and the production tools, means are simple, and the cost is low. It is recommended to use stainless steel corner code and stainless steel corner code screws in the production of cabinet base cabinets.

Needless to say, the three-in-one connection method, we all know that the wardrobe back panel depends on what thickness you use, if it is a 9MM back panel, you need to groove on the 2 side panels and the top and bottom plates, and then the 9MM back panel is embedded in it, if it is an 18MM back panel, it needs to be wrapped by the side panel and the top and bottom plate to install the row holes, so that in addition to the wardrobe and the back of the wardrobe, other directions can not be seen, in addition, it should be noted that if the 9MM back plate is used, According to the size of the wardrobe, you need to use 1 or several pull strips to connect and fix it in the middle.

Three-in-one, two-in-one, triangle iron, wire + nut + crescent, in addition to the gunnail, there is a combination of invisible components, but with plastic accessories. The latest one is the invisible combination without accessories.

Three-in-one, two-in-one, triangle, wire + nut + crescent, gun nail.

Panel furniture is connected with hardware.