What to do with the wall on the sliding door of the bathroom

Updated on Bathroom 2024-01-27
7 answers
  1. Anonymous users2024-01-23

    Reinforcement on it, if the area is large, you can smash it off and then reinforce it on the top, continue to build it with red bricks, and then plaster it, see what you do door frames, if it is a light door to increase the width of the meter! m * high meter height above the ground with concrete steel bar intersection level, against the old wall.

  2. Anonymous users2024-01-22

    In order to ensure that the glass partition in the bathroom is more beautiful, the sliding door is generally chosen as the sanitary partition. Be sure to measure the actual size of the bathroom glass partition again after laying the floor tiles and wall tiles before installation, so as to avoid some large errors on the upper and lower walls, so be sure to measure the size again. The sewer work should be carried out beforehand, and the floor drain should be installed in conjunction with the use.

    If the glass sliding door has a door frame, it can be used directly, and if not, it is also necessary to use a sill stone to achieve the effect of water retention.

    In order to facilitate the use and maintenance of the bathroom, you must not use the slide in the partition of the bathroom, because after a long period of use, there will be a lot of moisture and garbage accumulated in the slide, and it will be difficult to clean and maintain.

  3. Anonymous users2024-01-21

    You don't need to smash it, just make a sliding door.

  4. Anonymous users2024-01-20

    Depending on what door frame you make, if it is a light door, knock it to the wideRice! m * highmeters above the ground height with concrete steel bar cross horizontally, against the old wall.

  5. Anonymous users2024-01-19

    It's best not to smash it, it's expensive and laborious, and it's just a matter of sprinkling it.

  6. Anonymous users2024-01-18

    Your question is not detailed, please be specific.

  7. Anonymous users2024-01-17

    The door of the bathroom is generally hanging and slippery, and the wall above does not need to be smashed, because the wall above should be installed with a track, and the track can not be on after smashing, the solution is very simple, that is, stick the wall tiles of your bathroom, and the corner of the sun should touch the corner to look good.

Related questions
How to deal with the sliding door partition in the bathroom?
7 answers2024-01-27

Hello, the general sliding doors are plastic products, if it is iron, it is good to connect some plastic ones, and they can only be replaced.

Sliding doors in the bathroom
9 answers2024-01-27

If it is facing the living room, it is best to make the color of the sliding door the same as the color of the wall, so that the wall will be visually seen as one, and I don't know if it fits the situation of your home. I'm also in the process of decorating, and the carpentry has just finished.

How to deal with the leakage of the bathroom downstairs
3 answers2024-01-27

There are two possibilities for the first thing to check is the leakage of the water source. >>>More

How to deal with leakage in the bathroom wall
4 answers2024-01-27

First, ask if there is a water leak downstairs. How long has this been happening in your family? If there is also a leak downstairs and it has happened recently. The permeable area of the wall expands rapidly. Then it can be concluded that the water pipe has burst. >>>More

How to deal with the paint off the wooden door in the bathroom
10 answers2024-01-27

1. Before repairing important parts, you should protect them to prevent them from being sprayed with paint, and wrap them in paper and stick them gently. >>>More