-
Anonymous users2024-01-23If the mobile phone is flooded, you need to perform the following operations:1Disassemble the whole machine and prepare it for use with the appropriate screwdriver.
2.When removing the screen, gently separate the chiplet to which the screen is connected to the motherboard from the motherboard. 3.
Before removing the metal shielding insulator, the network access card and the card slot sticker under the network access card must be torn off. 4.Take a hair dryer to dry blow, not blow on the screen for a long time, such a high temperature will destroy the screen 5
Blow the front and back of the motherboard to ensure that there is no moisture left, and try to blow out the water at the earpiece. 6.Put the disassembled mobile phone in a noisy place, preferably for about two days, and then install it.
Close the water valve and remove the water inlet to clean up.
The toilet has been on the water solution:
1. You can check whether the flush switch is restored to its original state, because the flush switch in some toilets is easy to wear out after being used for a long time, or it is stuck, so it cannot be restored. Typically, the switch can be reset by repeating it a few times. >>>More
The water inlet does not stop, first observe the water level of the water tank: the water level is high, and the water flows out from the Xiaocha overflow, which is the problem of the water inlet valve; The water level is low, and the water flows out of the flush port, which is a problem with the flush valve. FYI.
The toilet inlet valve is broken, and there are the following solutions: >>>More
How to deal with leakage of toilet inlet valve.
1. Check whether the flush switch is reset. The plastic flush switch of some flush toilets has been worn for a long time, and occasionally there will be a phenomenon that it cannot be reset, if it cannot be reset, then it can be switched on and off several times, so that it can be reset. There is also to check whether the rubber gasket of the drain port under the ball valve is aging, the sealing is not tight, etc., and if the problem is found, it should be replaced, so as not to affect the use. >>>More