How to design a bathroom in 1 11 5

It is recommended that the landlord design the water supply and water location of the original building, and the bathroom meets the specific use functions of the public, such as hand washing, toileting, rain or bathtub, etc., and then carries out specific design according to the owner's use needs and budget requirements. Decoration form and material selection, it is recommended to combine the overall house decoration style for specific design, for example, European style and modern bathroom material selection will be different.

How to design the bathroom big barrage! Hello, I am glad to answer for you the <> bathroom design method is as follows: with a sliding door handle, the slide rail is better on the hanging rail, the ground rail will be difficult to push and pull if there is dust, the ground installation of the ground rail is not easy to use 1, the circuit goes to the top surface, lighting and power must be separated, such as the water heater and hot water treasure is the power line, the wire diameter is relatively large, the electric water heater wire diameter is a zero line 4 square millimeters, a live wire 4 square millimeters, a grounding wire square millimeter, in the empty opening there is a single spring limb double piece double branch with leakage protector of the empty opening, relatively safe.

2. The position of the bucket water heater is on the side of the door, and it is basically invisible when entering the door, which is troublesome, but the visual effect is good, in fact, most of the visual effects come from neatness, and there is nothing to see if it is not tidy. 3. Most of the water heaters are installed in the guest bathroom, the height is enough, if it is installed in the main bathroom, it can only be installed on the side of the bathroom door head-on, the bath bomb heater and lighting and ordinary sockets are all the way empty, in addition to the lighting to millimeter wires. 4. The smart toilet should reserve a socket, a three-hole socket, don't forget that the power is not large (usually 1500W), it should be a separate way, an ordinary three-hole socket, the usual location is:

The toilet is on the left hand side, the height does not exceed the height of the water tank, and it is ten centimeters away from the water tank. 5. Hot water pipes replace cold water pipes, and it is possible that the wall thickness of cold water is thin and easy to be broken by large particles, or at least there is damage. The shower should pay attention to the direction, try to avoid the door and the direction of the toilet, the wall of the shower spray should be facing the outer wall or the wall of the bathroom next door, and the waterproof paint should be rolled three times at a height of meters.

6. The floor drain in the wet area is directly below the shower, 30 cm away from the wall, and the floor drain in the dry area is close to the water retaining strip in the wet area, and the position is very important. Hope mine can help you <>

Do you have any other questions?