How to use toilet plugs

Here's how to use the toilet plug: Tools: toilet plugs, brushes, toilets.

1. First add water to the toilet, and then when you see that the amount of water can have a certain momentum, Zhenqing aligns the toilet plug at the mouth of the toilet bowl and presses it violently.

>2. If it doesn't work, add water again, press again, and use the impact air flow generated by repeatedly squeezing the rubber bowl to push the dirt out of the pipe.

>3. Buy the long bridge handle of the banquet brigade, and the other end is a round toilet brush, and the brush head is wrapped in a plastic bag when the toilet is blocked.

>4. Then tie it tightly to the brush handle, and then add water to the toilet mouth to flush the toilet back and forth.

Here's how to use the toilet stopper:

1. Repeated pressing, when using the toilet stopper, press the rubber bowl of the toilet plug repeatedly, so that the pants will produce airflow, so that the dirty things blocked in the toilet can be pushed out of the toilet, and the dirty things in the toilet can also be pulled out after pressing the toilet stopper, so that the toilet is dredged.

2. Add a certain amount of water, we can add more water to the toilet, and wait until the water in the toilet has a certain momentum, and then align the toilet plug with the mouth of the toilet bowl and press it hard.

How to unclog the toilet bowl

1. Before dredging, you should go to the market or supermarket to buy a water puller, put the rubber end of the water puller against the mouth of the toilet, and then press it down hard, and then lift it up and press it again, so try a few more times, and the toilet will be dredged.

2. Steel wire hanger dredging method, if the skin hanger can not be dredged, you can find a wire hanger, pull the wire hanger into the bay, and then go deep into the pipeline, twist, push and manipulate the wire in a circle to clean the pipeline.

3. Baking soda and vinegar dredging method, you can pour baking soda and vinegar into the toilet, it will hiss when the vinegar is poured, stop adding vinegar when foam comes out of the toilet, and then pour 3 to 4 liters of hot water into the toilet bowl to help dissolve baking soda and vinegar, which can also effectively dredge the toilet.

Put a part of the water in the toilet, use the toilet bowl to plug the bottom of the toilet bowl and pull it back and forth, use the vacuum to impact the water flow, and let the water flow flush the blockage into the pipe.

Align the toilet plug in the middle of the toilet bowl and push down repeatedly.

Answer: A toilet plug is an extremely versatile device for unclogging sewer pipes. Typically, it consists of a bowl-shaped rubber head and a wooden rod-like handle embedded in it. Before use, the floor drain and the hair at the grate should be cleaned, and the overflow hole of the pool should be blocked with a damp cloth if it is possible to clean the pool.

The bowl-shaped rubber head is facing down against the mouth of the sewer pipe or constantly pushing down so that the air is forcibly pushed into the pipe; Or press down hard, and quickly pull back when the rubber head is pressed, resulting in a vacuum state. The aim is to loosen or spread the blockage in the sewer pipe. When there is water in the sewer pipe, it is more effective to use a toilet plug to dredge it, because the water is difficult to compress and thus transmits the pressure applied more than air.

When the toilet pump fails, other methods are often used, such as using chemical reagents or spring wire rotary dredging devices.

Question: Hello, how to use the toilet plug of the toilet.

What should I do if I can't press it?

It's small, this one.

This one is more like a child's toy

The water is not over the rubber semicircle of the toilet plug, and the surrounding area is good, try not to have a seam, press it down, and then wait for the recovery to press it down, but I think you are too small and not strong enough.