-
Anonymous users2024-01-23The toilet shifter is usually installed by lowering the plane of the original sewer pipe to make up for the installation height of the shifter (about 6 cm), so that the toilet is still installed at the height of the ground, if it is higher than the ground, it is usually used to make the plane with the height of the shifter, and then install the toilet at the height of the bottom of the toilet and its squatting range.
-
Anonymous users2024-01-22It can be installed, but it should be heightened, a layer of pads under the toilet, the heightened part, and the side should be tiled, otherwise it will not look good, and then your toilet will be a little higher, hehe, try to buy a better shifter, and don't buy a cheap flange under the excuse, the problem is that these places are prone to problems, and there is no problem with normal use.
-
Anonymous users2024-01-21It can be decorated. However, after installing the shift, it is easy to cause toilet blockage, and after installing the shift, due to the increase in curves, the air pressure increases, and it is easy to cause backflow. It is recommended that the toilet shifter can not be used as much as possible, and I heard that there are many cases of toilet blockage.
-
Anonymous users2024-01-20This can't be installed, as long as you find a way not to get above the plane, you can use it.
Toilet shifter: also known as offset, drain shifter;It is mainly used for toilet installation, because the position of the toilet wall and the sewage outlet is fixed, and the selected toilet sewage outlet and the lower sewage outlet do not correspond to the position of the pipe fittings used in the case of incomplete docking. >>>More
1. It is not recommended to use electric hot water and gas water heaters above the ceiling, and mechanical or wire control is not good, which is not conducive to heat dissipation, installation, maintenance and inspection. After the original water heater was removed, there were two water pipe heads left on the wall, which were usable, and there was a sewer on it, and the height of the whole space was relatively low. As long as the water heater is larger, your house is at least high, and the ceiling is enough. >>>More
1.The first thing to do is to see what type of toilet (split and conjoined) you are supplemented: the conjoined is that the toilet and the cistern are not fixed by screws, and the split is that the toilet and the cistern are fixed by screws. >>>More
It is not recommended to install it to the top corner, the front and accent are mounted to the front TV 2 side, the accent is mounted under the TV, and the rear is mounted on the sofa 2 side. Add the curtain and there will be no reverberation.
It is necessary to prepare the necessary tools before the installation of the water purifier, and the following tools are generally required for the installation of household water purifiers: percussion drill punching (drill bit with 6 points or 8 points) or opening (hole opener 11-16mm) for fixing the direct drinking machine. Raw tape can be used to wrap the joints to prevent water leakage. >>>More