How is a flat ceiling hoisted

Flat ceilings are also suspended flat ceilings. Hanging flat roof is generally higher floor height, the roof has central air conditioning or there is a pipeline, when saving costs, the flat roof is generally hung flat roof, flat top has mineral wool board, gypsum board, gusset plate and other forms, the structure of hanging flat roof is generally connected with screw rod or wooden keel, light steel main keel, auxiliary keel connection surface material. Suspended ceilings are divided into flat roofs and modeling roofs.

A flat top is the simplest, and the top surface is all on a flat surface. The top of the modeling is more complicated, the top surface may have multiple stacks, and it will also contain special effects such as concave circles, concave light grooves and other shapes. High-end catering and entertainment venues will make modeling roofs to enhance the decoration effect.

The method of keel hanging flat top is very simple, and the specific operation steps are as follows:

1) First, measure the length and width of the flat roof of the living room, calculate the amount of decorative board required, and then calculate the amount of wood strips according to the size of the flat roof and the size of the decorative board.

2) Prepare wooden keel, that is, wooden strips. The thickness of the strips should be consistent, and the length of the expansion screws should be taken into account when determining the thickness of the strips. At the same time, the decorative panel is prepared.

3) According to the size of the decorative board, determine the grade of the wooden keel. Use the pink bullet line to pop the center line or edge of the keel position on the flat item.

4) Select a percussion drill bit that matches the diameter of the expansion screw, and drill the hole in the flat-topped keel with a pistol drill. When punching, the matching wooden keel can be pasted on the flat top to ensure the accuracy of the keel installation, and at the same time, the material is numbered to prevent confusion during installation.

5) In order to prevent the expansion screw from growing out of the thickness of the wooden strip, the exposed part should be of the same length during installation.

6) The hole of the wooden strip should be larger than the screw, so as to avoid the screw from outcropping after tightening. After the opening is made, the wooden strip is put on the screw on the flat top, and after the nut is set, it is tightened with a socket wrench, so that the long row of wooden keels are all installed on the flat top.

7) Horizontal short wooden strips, installed with round nails, and make the flat-topped wooden keel Z-shaped.

8) Draw the center line with a pen on the installed wooden keel as the basis for laying the decorative board.

9) Finally install the decorative plate. Knock out the nail head of the 25 mm nail first, then nail the fixed position around the decorative plate first, and then repair the nail at 15 cm intervals. After installation, install floral chucks at the four corners of the decorative plate to increase the beauty and firmness.

Use a special screw for gypsum board to screw on the auxiliary keel.

Use a special screw for gypsum board to screw on the auxiliary keel. Check out the original post" to adopt.