-
The fittings are glue connections, check ports, quick connections are not high, see what you need. Don't forget to add a fire arrester!
It is best to take the spacing in the pipe of the H-through pipe fittings as the standard.
1. If you want to change the PVC sewer riser in all bathrooms, you must first cut off the tee and then re-bond it.
The bottom of the riser pvc110 tee is 30-35 cm away from the top plate surface, the expansion joint is installed below the tee, the floor drain and shower are all using the S bend with a cap, the basin is installed with a 90-degree cap elbow, and the S bend can be deodorized when installing the basin on this floor, and the kitchen sink drainage branch is installed on this floor, and the P bend with a cap is directly installed, I hope it can help you. It should also be noted that the smaller the distance between the tee and the top, the greater the net height of the bathroom.
If it is a tee on the riser, it is not easy to operate, but you should insert the bottom of the tee as much as possible. For the upper mouth corresponding to the lower mouth, it is generally not easy to leak water on the upper mouth. >>>More
Go to the hardware store to buy PVC pipes, PVC special glue, small hacksaws, and rulers.