In the kitchen, there are 2 sockets in one circuit, and the convex is often used, but the other N ze

Updated on Kitchen 2024-10-06
1 answers
  1. Anonymous users2024-01-24

    Normally, when plugging in the electrical appliances and using them, a circuit will be generated, and all the change will be connected back to a point, and there will be no electricity after the electrical appliances are disconnected.

Related questions
There are two sockets in the kitchen, one socket has electricity and the other socket has no electri
1 answers2024-10-06

The wires are not connected, open the panel and test it clearly. Reconnect it, tighten the screws on the binding post, and check that the wires are not connected incorrectly. The live wire is connected to L, the neutral wire is connected to N, and the ground wire is connected to E.

Kitchen sockets and air conditioning sockets are a circuit breaker with how big it is
1 answers2024-10-06

It is best to use the air conditioning socket separately for power supply, if it is not good to transform, you can use a 25A leakage protector.

In the kitchen, there is electricity in one socket, and the other sockets are not electric, and the
4 answers2024-10-06

The contact between the wire and the socket is not good, turn off the main power supply, and then remove this socket, the screws on the terminal at the back are loose, and you can tighten it. >>>More

Kitchen lighting and sockets are not a circuit
2 answers2024-10-06

According to national regulations, it is not a circuit, if it is after decoration, it should be checked whether it has been changed to a road.

Is one circuit of the dining room and kitchen socket in the residence sufficient?
1 answers2024-10-06

If the leakage switch and wire cross-section meet the requirements, there is certainly no problem with a loop bearing, but it is still recommended that the kitchen and the Chinese restaurant be separated to prevent the kitchen or Chinese restaurant equipment from jumping out and affecting each other.