-
Anonymous users2024-01-24In this case, it is likely that the circuit board is burned out, and it is enough to replace a control panel, which is generally not expensive. Because most of the control panels are similar, they may also be common to other brands of manufacturers, so if you can't find the original manufacturer, you can also go to the sales office of other brands to see, and it is estimated that you will charge more service fertilizer, generally more than 200 yuan.
-
Anonymous users2024-01-23The first is that your wiring is broken, which is caused by the deterioration of the wiring caused by the humidity of the steam you have been using for several years; According to what you said, there is no major problem with your circuit board, remind you not to use it again, it may cause leakage due to short circuit. If you go to someone at a home appliance repair center near where you live and get your meter to test, it's best to find an acquaintance, because your bath room will lie to you.
-
Anonymous users2024-01-22I'm buying one, the shower room is so cheap now, isn't it?
The wheels of each manufacturer are different, it can be said that there are hundreds or thousands, try to find the original manufacturer with one, otherwise you can only make do with it.
You are talking about the bottom basin or stone base of the shower room, as long as your bottom basin or stone base can be moved, not connected to the wall or ground, it can be replaced, and it is also convenient, as long as the shower is folded down and replaced with a bottom basin or stone base, and then the shower room can be installed, but if it is connected to the wall, it is more troublesome. What I'm talking about is that the shower room is not a steam room, and if the steam room is broken, it will be troublesome, and the structure of the waterway circuit is a bit complicated.
The old-fashioned means that the service life is relatively long, basically after the warranty period, you can use the tool to remove the broken pulley and then buy the same model or size of the pulley to replace.
For the installation of pulleys on the glass sliding door of the bathroom shower room, the wheels should be installed on the door first, then the wheels should be adjusted to the lowest position, then the door should be installed with the card slot, and finally the wheels should be raised to the appropriate position. >>>More
According to the model of your shower room, you can buy pulleys from merchants who sell shower rooms in the building materials market, and then find a worker to install them, which is not very troublesome.