-
Hello: Maybe you are buying a toilet with a spin into the water, not a toilet with a straight flush. Spin down, flush down and float up a layer of your toilet drain, about 2-4 cm, straight down a little less cheap than this.
There is a way to put a layer of toilet paper in the water when you defecate, it will not be cheap, and it is not recommended to use it for a long time, which is easy to cause blockage of the sewer pipe.
-
That's the water level reserved in the toilet, and you may not be able to solve this personally!
-
That's because the water level is too high and the water is splashing. You can consult the merchant at the time of purchase.
-
...The problem of the toilet is that there is a lot of reserved water.
Or maybe the slope is not enough.
-
Sometimes the water is too low.
The toilet design is not reasonable, and if the water is stored too deep, it will splash PP. The temporary solution is 1Start by laying a piece of paper on the surface of the water. >>>More
Before going to the toilet, putting a piece of toilet paper in it can solve this problem, and there should be corresponding facilities online to solve this problem.
You can only change the toilet and change it with a big momentum.
It's very simple, tear a piece of tissue paper and throw it flat into the toilet bowl where it corresponds to the landing point.
Before sitting down, put a tissue on the surface of the toilet bowl and let it float on the water, and after doing so, there will be no water splashing out when flushing.