-
Anonymous users2024-01-24After the wall is waterproofed, the water absorption rate is greatly reduced, which is a difficult test for tile maintenance. The slurry is too thin to hang the bricks, and the slurry is too thick to bulge after pasting. It is recommended to use tile glue, or add glue or JS to the slurry.
-
Anonymous users2024-01-23Caused by temperature!
Knock down the bulging, use tile adhesive + cement paving, pay attention to the temperature in winter construction, and prevent the cement from freezing and cracking when it is not solidified.
-
Anonymous users2024-01-22The wall can not be made of waterproof paint, and the tiles will not be used to penetrate the crystalline tiles, and you will find some professionals to do a good job.
It's easy to determine if a water pipe is leaking, and you can find a plumber to do a sewer pressure test to know if the water pipe is leaking. If it is not a leaking pipe, it is that the waterproofing of the wall and the ground is not done, and it is difficult to re-do the waterproofing now, and only by knocking off the wall tiles can the waterproofing be done. You can find someone who does stone care, cut all the gaps in the walls and floor tiles wide, then fill in the marble glue and polish it smooth. >>>More
It's not that the waterproof is not good, but the water is stored in the waterproof layer, and there is a role of water diversion to make the two bedrooms seepage at the same time, make the waterproof layer a little higher so that the water can be smoothly removed from the floor drain and toilet outlet, and it will solve your problem, and the waterproof around it will be a little higher.
If the wall of your bathroom is very flat, you can consider using adhesive to apply tiles, with a thickness of only about 3 mm + tile thickness. >>>More
Deal with the bricks, of course, but also look at how your original waterproofing is done, there should be no problem for a few years, free professional technical consultation on waterproof leakage repair.
It depends on how your hole is made?
If the brick joint is porous due to decoration, it can be filled with white caulk (the wall is white), if the surface of the brick is damaged because of the decoration, it is recommended to knock off the broken brick and replace it with a new one; If the brick itself is with holes, then keep it, and the artistic atmosphere is stronger! >>>More