If you want to install a bath bomb in the bathroom, but there is no multi core cable for the reserve

Upstairs said to be fully open, including bath bomb lighting, bath bomb bulbs (generally two groups), bath bomb exhaust fan, there is no group control, you can use a three-way remote control switch to solve. As shown in the figure below.

The remote control can be fixed on the wall, or it can be taken out to use, which is very convenient. That's how my family solves it!

There are 3 ways to do this:

1. Re-route, if there is a line pipe, it is very easy to do, put on the flat line of 4 to 5 roads, the polycentric line is not ideal, too small, and some are only more than 1 flat. So pull up 4 to 5 flat lines individually.

2. Like the brother gave the picture, buy a remote control splitter, and a wire on the top is enough.

3. It is the line and together, open and bright, but it is not safe, the instantaneous voltage is too high, it is easy to short circuit, the switch may burn out, and it may cause potential safety hazards!

Therefore, it is best to re-thread it, see how many controls you need, if it is a traditional old bath bomb, every 2 bulbs a route, don't 4 and all the way, I am afraid that the switch and the wire will not be bearable.

Bath bombs don't need multi-core cables, right?,Ordinary wires are fine··· What do you mean, be clear.