How to remove the plastic film on the security door

The plastic film is to protect the security door from wear and tear, and it is easy to tear when it just leaves the factory, but the longer the plastic ages, the more difficult it is to tear. It is recommended to tear it off immediately after the decoration is completed, otherwise it will be difficult to tear it off after a long time.

The newly installed door should be easier to tear, you can find a thicker plastic film that is not worn out from there, slowly pull it up, and after opening the breakthrough, you can tear it off smoothly.

Use a hair dryer, turn on the hot air, blow it, and it is estimated that it will be removed.

Answer: Mix dish soap and laundry detergent with warm water, stir and then apply a towel dipped in water on the air-dried plastic film several times, and then gently brush it off with a soft brush after a period of time. We often use a hair dryer to remove the glue of the label, or we can tear up the plastic film while using a hair dryer to blow on the torn notch, the temperature can not be too high, and if it can't be torn off, spray some glue remover, and wipe it with a dry towel immediately. Feimojun has seen the aunts who clean the wasteland scraping back and forth with a plastic scraper, and you can also try it.

If it is a small area that cannot be removed, you can wipe it back and forth with a cotton pad dipped in alcohol or wind oil essence, the viscosity and adhesion will weaken, and you will soon see the residual film gum scraping loose, and then wipe it several times with a dry towel to become clean. I've seen some netizens say that they use rosin perfume, banana water, and asphalt cleaners used for cars to apply to the surface. Feimojun thinks that you can try the anti-theft door with a sprayed plastic surface, otherwise the paint on the surface will be dissolved.

It is best to wear gloves and a mask when using chemical agents.

Asked which adhesive remover to use, I tried it with boiling water and dish soap, but I didn't use it, I blew it with a hair dryer, it didn't work, and the area was not small.

Or scrub with banana water.

Ask: 95% or 75% is better? Or does the use of self-adhesive adhesive remover have an effect on the paint on the door? What banana water is used?

Using a self-adhesive remover will have no effect on the paint on the door.

You can wipe it with a warm cloth first, and then find a head to start tearing, if it is not easy to get it, use an eraser to find a beginning.

Dip a cloth in "Tianna water" to wipe off the plastic film left on the stainless steel door.

Use a hair dryer, the kind that blows hot air, and peels it off while blowing. Maybe it's easy to get it,

Tear it off slowly and wipe it again after applying dish soap or detergent to a dishcloth.

Quickly inspect it with a cloth a few times to make the surface heat up, and the plastic film will be better.

Wipe it with a damp towel and you're done!

The best thing to do is to call the place where you bought the security door.

They'll tell you what's best.