-
Anonymous users2024-01-24There is a big hole in the drain of the toilet toilet and it must be replaced with a new one, which is extremely harmful if it is not repaired;
1. The drain of the toilet bowl has broken a big hole, and continued use will lead to water leakage, who can bear the dirty water all over the ground, that is, the ground waterproofing is done well, and the stagnant water will accumulate over time and emit odor to the bathroom. Of course, it will also seep into the downstairs as time grows.
2. The drain pipe is broken, the original water seal is also destroyed, and the odor in the sewer pipe will come out of the hole in large quantities, and the bathroom will be full of smell.
So the toilet drain has a big hole and must be replaced with a new one immediately.
-
Anonymous users2024-01-23It will lead to water leakage, and if the ground is waterproofed well, the stagnant water will accumulate over time and spread to the surrounding walls. Of course, over time, it will seep into the downstairs. Therefore, if there are conditions, it is best to find someone to make up or replace it.
-
Anonymous users2024-01-22It's not good to make up, it's better to change one, it will breed small insects in summer.
-
Anonymous users2024-01-21I did repairs a few years ago, and the repair method is as follows:
1 Flush with water, preferably with a toilet brush.
2 Use a cloth or paper towel to water around and around the hole.
Wipe dry, and at the same time have a genus.
Underwater current, if there is a downward stream I'll wait.
3 Use coarse sandpaper below 400 mesh to polish the perimeter of the hole to make it less shiny.
4 CUT A PIECE OF PAPER WITH SCISSORS, THE SHAPE IS SIMILAR TO THE HOLE, AND THE FOUR SHOULD BE ABOUT 10MM WIDE, AND FIND A WAY TO PASTE IT. (Small holes are not used).
5. ADJUST THE SPECIAL GLUE AB FOR CRUSHING AND REPAIRING THE URINAL WITH A SCRAPER, AND WIPE THE SPECIAL GLUE FOR CRUSHING AND REPAIRING THE URINAL ON THE PAPER, AND THE WIDTH OF THE PAPER IS 20-30MM AROUND
6 DEPENDING ON THE SITUATION, AFTER THE SPECIAL GLUE FOR THE BROKEN REPAIR OF THE URINAL WIPED IN STEP 5 IS CURED, IT CAN BE WIPED AGAIN TO ENSURE THAT THE THICKNESS REACHES MORE THAN 3MM. (A small hole of 2MM is fine).
7. It can not be wet within ten hours, and the colloid can be used normally after the colloid is fully cured.
There is a lot of knowledge about the direct flushing toilet, 60MM is generally not blocked, but sometimes the water volume should be considered, the height of the floor, the direct flush is generally suitable for the 3rd floor or below the third floor, the water volume is set freely according to the needs of the user, the remaining water float is lower, but too low may not be able to flush down and block. THERE IS ALSO THE BRAND, AND THE TOILET BRAND ON THE MARKET ALSO DETERMINES THE PERFORMANCE, SO THIS IS ALSO A COMPLICATED ISSUE, BUT AS FAR AS YOU SAID, THE 60MM STRAIGHT TO THE THIRD FLOOR AND BELOW GENERALLY WILL NOT BE BLOCKED.
It is best to reserve 30CM or 40CM;
The toilets on the market are generally these two distances, but it is best to leave 40CM, which is convenient to rebuild in the future, and it is easy to buy a toilet. >>>More
A large part of it is unified, you can change the water-saving fittings, but you have to measure the height of the water tank to choose the right water parts, and the water inlet can only be installed below, if it is on the side, it cannot be installed.
You can use the toilet with 300 water outlets, it doesn't matter if it's one centimeter worse. Because there is a certain distance between the spout of the toilet itself and the drain reserved on the ground when installing, provided that your floor and wall are vertical.
Manholes. Hands can reach in and replace and disassemble the drain.