Does it affect the low installation position of the toilet inlet pipe in the toilet?

The water valve is very well installed, remove the heel on the valve screwdriver, take off the flat gasket, insert the water valve from the small round hole of the water tank and hold it with your hand to find a good direction, do not let the float and other accessories in the box have contact with each other, find the flat gasket with the other hand and put it on the thread buckle of the water valve, tighten the thread with the mother on the water tank, connect the hose to the water inlet pipe mouth of the valve, and connect the angle valve at the other end.

According to the reason, there is no need to dismantle the toilet, the worst case is to remove the water tank, remove the water tank to replace the internal part of the broken accessories, and the worst case is to replace all the accessories in the water tank, which should not be too expensive, and work for one or two hours.

If the equipment is plugged in, the water pipe is electrified, then focus on detecting the electrical appliance to see where it leaks. >>>More

This is a crack in the water pipe or a problem with the two joints, you can ask a professional maintenance person to deal with your own house, and you can find a property in the building.

The valve of the inlet pipe is at the top of the inlet pipe, when the water level of the water tank is low, the tap water will enter the water tank through the inlet valve, and when the water in the water tank rises to a certain level, the float that controls the inlet valve will be jacked up, and then the inlet valve will be closed. When the inlet valve is in the water, you can find its location by pulling the float by hand and looking at it.