-
Anonymous users2024-01-24The shower wall is connected to the restaurant and the wall is damp and mildew, first of all, the mold must be removed, the mildew is not serious, you can spray the wall mildew remover to kill the mold, protect the wall, the mildew on the wall should be shoveled out if the mildew is serious, and the putty powder should be re-matched, in order to prevent mildew from becoming moldy again, you can add antifungal agent to the putty and stir it on the wall after stirring, and then add the antifungal agent in the paint when brushing the wall paint, so as to prevent the wall from being damp and mildew.
-
Anonymous users2024-01-23This kind of problem is the most common, and it is necessary to do a good job of waterproofing first, and then do other treatments.
-
Anonymous users2024-01-22If the wall is damp and moldy, it is normal because the local climate is relatively humid or the back of the damp wall seeps water, which causes the wall to be damp.
1. Thoroughly clean the peeled and damp wall with a shovel.
2. Continue to remove the floating ash on the wall to prevent the floating ash from affecting the bonding strength.
3. Evenly brush the separator with a brush and apply it 2-3 times, with an interval of about 3 hours between each time.
4. After the isolator is dried, the putty can be scraped in batches, and the batch scraping time is not less than 24 hours each time.
5. After the putty is dried, carefully polish it with No. 180 sandpaper.
6. Clean the surface dust and paint latex paint 2-3 times, with an interval of about 6 hours between each time.
The expansion bolt is driven into the wall, and the trim frame is inserted into the expansion bolt.
The glue at the junction between the kitchen countertop and the wall will not fall off, and there are other places where there are connections when the answer is used up, so don't worry about this.
No. That wall was clearly load-bearing. Tear down the walls, the building falls, you die with them.
1 All two, one embedded iron, the other with chemical bolts implanted.
The leakage at the joint is generally all the original caulk first, then clean the sand and dust, fill the gap with waterproof mortar, and finally put on the waterproof, mildew-proof and weather-resistant glue to seal the most, which can solve the problem of water leakage.