The switch on the canopy was changed, and the water heater clicked when flushing the toilet, and the

Updated on Toilets 2024-09-25
4 answers
  1. Anonymous users2024-01-24

    Caused by insufficient or high pipe pressure.

    It is best to install a check valve in front of the water heater inlet pipe.

  2. Anonymous users2024-01-23

    Water hammer action. Changing the switch causes water resonance.

  3. Anonymous users2024-01-22

    It should be caused by water pressure, if according to you, the unkempt switch is changed, then it means that the water inlet of your water heater is long-passed, and the water outlet is controlled, and the water heater is turned off. When you boil the water, the water pressure in the water pipe becomes low, causing the water to resonate, which is the sound of the water pipe, and then when you turn off the water, the water pressure suddenly becomes high, and the water heater ignition controller ignites the fire, but at that moment, the water pressure is restored, so it only burns once.

  4. Anonymous users2024-01-21

    Turn off the inlet valve under the water heater to see if there is still such a phenomenon.

Related questions
The water heater is turned on and off in the toilet hole, so why do you need to do it urgently
1 answers2024-09-25

It's nothing to think about, if the water heater switch smashes the toilet, then wait until the toilet is replaced to pour it out. If the toilet is intact and does not need to be replaced, then you can only dig it out by hand, if it is dirty, you can go to the grocery store to buy a pair of rubber gloves (6 7 yuan), if you can't buy rubber gloves or don't want to buy, you can also find a big plastic bag with your hands and arms together and reach out and take it out.

The water heater at home is far away from the toilet, and you have to put a lot of cold water every
3 answers2024-09-25

The circulating pump is heating heating, it is a water pump, accelerating the water flow speed of the heating pipeline, so that the water flow rate of the boiler and the radiator is accelerated, so that the heating water temperature is not high, and the water temperature at the radiator is low. You can take a bucket of cold water to your house, wash clothes, wash mops, flush toilets, this is not a solution.

Why is it that when you use a water heater, the temperature of the kitchen water is very high, but t
4 answers2024-09-25

It is estimated that the hot water pipe was not insulated during the renovation, and the water heater was very close to the kitchen, and this situation would occur far away from the bathroom. >>>More

The leakage switch that controls the water heater is installed in the corner of the toilet, and the
2 answers2024-09-25

It stands to reason that electrical appliances cannot be installed in the noisy places. This is because the temperature of the wall is usually low, and the water vapor will form condensation on the surface of the wall, which will enter the conductive part through the gaps. On the other hand, water vapor will also enter the metal parts of the electrical switch through the gap and condense into water, and when the water forms a water flow, it will conduct electricity. >>>More

As soon as the bathroom presses the switch of the exhaust fan, the water heater trips, what is the r
6 answers2024-09-25

Explain that the anti-interference performance of your water heater leakage protector has deteriorated, and the ignition phenomenon of the switch interferes with the leakage protection tripping, or you will decisively press the switch, why press it gently, the switch is strictly forbidden to touch the arc, or you will change to a new leakage protection.