-
Anonymous users2024-01-24It is very likely that it is a problem with the sealing ring, I have seen many friends who have such a problem, and often emit a foul smell, which unscrupulous decorators do in order to save time. It is recommended that you find a familiar one to get it.
-
Anonymous users2024-01-23This situation is mainly due to the fact that when the flush button is pressed, the water parts may not bounce back in time, so it will cause the water to continue to leak. Just open the lid of the water tank and check the water parts inside, and let the water pieces reset to the place. If you can't reset the water parts, it may be that the water parts are broken and you need to ask someone to replace them in time.
-
Anonymous users2024-01-22It is preliminarily judged that the sealing ring of the sewer valve in the water tank is not tightly sealed, or the sewer valve is damaged.
This problem can be solved by tightening the seal nut or replacing the drain valve.
-
Anonymous users2024-01-21The inlet valve is problematic: it will cause the water to keep coming in, and the water level will rise to full, but it will continue to flow from the overflow pipe on the drain valve to the toilet; If the seal on the drain valve is deformed or blocked by foreign objects, the water level will not rise and the water will slowly seep into the toilet.
-
Anonymous users2024-01-20The float valve inside the water tank is stuck due to scale and other reasons, and the water cannot be stopped normally. Take it out and clean it, if it doesn't work, you can only replace it with a new one.
-
Anonymous users2024-01-19There may be a problem with the float in the toilet tank, or there may be a problem with the sealing ring, just open it and see!
If there is water, there must be a water source. Is it underfloor heating above the living room? Make the living room environment clearer. >>>More
It could be that the float valve is broken.
Open the toilet lid, check that the float is in normal position and all parts are in good condition, remove the water inlet valve, and clean all the parts that can be removed with a brush, especially the rubber pad, which is normal after installation. The toilet has been used for a long time, and the inlet valve has accumulated debris and formed a slippery scale, and the air pressure water valve cannot be closed normally if it leaks. >>>More
Open the lid of the water tank, there is a plastic float, just move it with your hands. The float is stuck.
Hello! 1. The walls of the kitchen on the 3rd and 4th floors have water seepage (I didn't knock on the wall at all when I was decorating, just pasted pool bricks on the wall), who is responsible? >>>More
The water valve in the water storage tank is not tightly closed, the plug is deformed, the drainage outlet is not tightly closed, the impurities under the plug are not tightly closed, the chain of the plug is too short, and there is a mechanical failure stuck, etc., which will cause water seepage into the toilet