-
Hello! This problem is not difficult to solve, use the nine-centimeter board to dig out the appropriate size of the downlight lamp hole, and then use glass glue to dip on the back of the aluminum gusset plate and then on the hole of the aluminum gusset, and then you can install the lamp when the glue is dry.
Not the same, the lamp on the aluminum gusset uses an integrated wire plate, which is consistent with the size of a gusset, easy to install, after buying the gusset to choose the light board, the seller will take out a variety of light boards for you to choose (the light board has generally been integrated into the gusset by the merchant) The ceiling is completed and the position of a gusset is reserved in the center of the gusset to directly buckle the light board, (the same as the method of the gusset buckle).
Using a suction cup, suck in, and move away.
Go give it a try, and ask me again if you don't understand. >>>More
I heard that Phidley Lighting doesDownlight It's okay, a lot of it can be customized, his buckle, I'm looking for it, a surname Huang, it's 235451001. >>>More
Come according to your floor height.
Net height - ceiling design height = boom length The length of the point should be cut in the middle, and the ceiling can not be poked, generally the height on the top surface is about -5 cm. >>>More
Generally, there are no guests, and there is no need to open the light strip, so you can install the downlight on the ceiling. >>>More