The water switch next to the toilet did not respond at all after it was turned on, and the sound of

Updated on Toilet 2024-09-02
2 answers
  1. Anonymous users2024-01-24

    1 first check the water source to see if there is tap water, if there is, 2 then check whether the tank door is open, if it is indeed open, 3 open the water tank, check whether the float is stuck (stop at a high position), if so, just put it down.

  2. Anonymous users2024-01-23

    Do you live on a high-rise floor and the water pressure is not enough?

Related questions
The toilet press it and it doesn't react, it can't be filled with water, it can't be charged at all,
3 answers2024-09-02

Open the lid of the water tank, and nine times out of ten the rope inside is broken, just connect it.

The toilet inlet switch has been flooding after it is turned on, and the water is also entering the
1 answers2024-09-02

First,see if there is a problem with the float,water ingress or deformation and displacement will cause the water to be unable to turn off normally.Li

How to make the toilet bowl a little less water
2 answers2024-09-02

Open the lid of the water tank, there is a device that can adjust the height of the water level, and the water level can be adjusted lower. In addition, you can also find a drink bottle, fill it with water and put it in the water tank, which can also reduce the amount of water in the water tank.

The toilet is clogged and doesn't go down at all!
6 answers2024-09-02

The toilet is clogged and there is no water at all; The toilet is clogged, usually at the drain bend, and the best and easiest way is... >>>More

How to unblock the clogged toilet, there is no water at all
2 answers2024-09-02

1. If the blockage is not very tight, go to the supermarket to buy a rubber suction for the toilet, and press it back and forth on the toilet bowl a few times, so that it is easier to pass when it is full of water >>>More