Is it OK to add a bathroom to the structural panel through the kitchen? Does this have anything to d

Updated on Kitchen 2024-09-02
1 answers
  1. Anonymous users2024-01-24

    It's not very good, the pipe is troublesome to connect, and the maintenance is tiring enough.

Related questions
The slab is 0 5 m low in the bathroom and 0 2 m low in the balcony, while in the rebar sampling it i
1 answers2024-09-02

There was a small impact, but it was minimal.

If you want to change it, it's very simple, from the guide once, it is very simple to define the elevation of the board. >>>More

What should I do if the toilet pipe in the bathroom leaks through the floor?
4 answers2024-09-02

Chisel out the pipe through the ground and replace it with a new section of pipe, and use mortar to hang the gap between the pipe and the hole, and then treat the connection between the pipe and the hole with water after drying. The amount of work is not large, mainly involving downstairs, and communication is more troublesome.

The board of the kitchen and bathroom is 5 cm higher than the height of the structural floor, but th
2 answers2024-09-02

You are the construction party and should ask for clarification on questioning the design representative in person during the review of the drawings. If it is omitted at that time, and there is any doubt during construction, you should question or consult the designer in time, how can this drawing guide the construction? This is the legitimate duty of both parties.

Bathroom to increase the requirements of the strip
2 answers2024-09-02

It is generally located at half of the height of the masonry, I remember that it should be 60mm thick, 2 6 main reinforcement, 6@200 distribution reinforcement, C25. >>>More

In the brick-concrete structure bathroom and kitchen, there is a crack of more than ten centimeters
3 answers2024-09-02

You're not a brick-concrete structure, it's a frame structure, and the wall is built at the back, and you have to lay bricks on top of it, and then paint it.