-
Anonymous users2024-01-24It is still easier to dismantle, but it is better to have spare floor tiles. Waterproofing is best to redo, the cost is not very high, don't save a small amount of money in the future, disturb the neighbors, not to say, soak your own wall and floor is not worth it. When repaving, pay attention to the height of the four corners, and don't buy the shiny ones in the small shop for floor drains, which will rust and affect the sewer and stain the floor tiles.
-
Anonymous users2024-01-23Anyway, if you want to smash, it is better to redo the waterproofing, and the lowest point of the slope must be at the location of the floor drain.
-
Anonymous users2024-01-22It is easier to dismantle, but it is a troublesome point to do waterproofing, and it takes a long time to do waterproofing. Or just put another layer on top of the floor tiles, so quickly.
Bathroom floor tiles are not suitable for dry paving, because they are more likely to fall off due to moisture, sinking, dry paving is easy to dismantle, do not use sharp tools to shovel when dismantling the base layer, do not destroy the waterproof, there is no need to redo waterproofing, if you want to redo waterproofing, you must clean the base layer to expose the original waterproofing, and there can be no sand particles on the surface.
1.The water does not flow to the floor drain and is caused by a mistake in laying the bricks. >>>More
According to the desired location of your bathing area, you go to the place where the stone is sold and ask them to cut two water retaining strips for you, and stick them to the ground with marble glue or glass glue.
Now the paving tiles are basically using the dry paving method, but the bathroom is best to use the wet paving method, which is not easy to seep water, but the wet paving method is easy to have hollow drums, so we must pay attention to check when paving.
Don't take that long, 24 hours is fine.