-
Anonymous users2024-01-24Your hanging flat roof is not very good-looking, you can hang a two-layer top, the horizontal part is designed as a two-layer roof, and other places hang a layer of top, showing a sense of hierarchy. In fact, you don't have to think about these, just find a ceiling company to help you solve all the design schemes, the current multi-level ceiling of the Firinx 3D integrated ceiling is good, just a few days ago to see. But you have this, it is expected that it will cost more than 8,000 to hang the multi-layer roof, you can go and ask, if you have any questions, you can contact
In fact, for how to decorate the design of the ceiling board with beams, the most important point is to be based on the horizontal.
The ceiling and modeling arrangement at the top should be based on this beam against the wall - close this 36 cm to make a small flat roof, and the rest will take care of it!
Pull out a wire and cut it from the middle, one end is connected to the upper end of the switch, and the cut one end is connected to the lower end, and that's it.
Changing one is changing, changing a bed is also changing, and it should have nothing to do with whether or not to change the bed after changing. It is recommended to unify and coordinate first, and then look at the next development.
You can share a drainage pipe, it will not affect any use, side by side (adjacent) installation is only the height of the two floors is different, and the floor of squatting should have a step higher than the floor of the toilet