How to build a toilet without a sewer in a semi basement? To be the most convenient and economical m

Updated on Bathroom 2024-09-27
2 answers
  1. Anonymous users2024-01-24

    I'm going to make a bathroom in the basement, so that if you need to use the toilet, you don't have to run back and forth. But the developer did not leave a water pipe, how to solve this?

    Fortunately, the master later told me, don't blame the developer for not leaving a water pipe in the basement! The toilet is equipped with a lift pump, which is so good that it can't be used.

    What is a Sewage Lift Pump?

    This is a kind of lifter, which can completely solve the problem of sewage discharge when there is no drainage pipe in the basement. When the toilet sewage flows into the lifting pump, the machine will automatically start, the water level rises, and the internal reamer will crush the dirt and then discharge it from the sewage outlet.

    Easy to install and odorless.

    It can be installed directly on the back of the toilet, against the wall, which does not take up space and is more conducive to drainage. As for the odor, after all, the ventilation of the basement is not very good, so there will basically be an activated carbon filter, so that the odor can be absorbed without worry.

    Easy to access. If there is a relatively large solid falling into the water tank, the lifting pump also comes with a check cover, and it can be opened and cleaned directly, which is very convenient.

    Not afraid of clogging. Speaking of which, surely some people will say that the basement toilet will not be clogged with a lift pump? As mentioned earlier, the lifting pump is a built-in reamer, for useless waste, it will be directly crushed, and then discharged, such a design, as long as it is not deliberately damaged, basically there will be no clogging problem.

    What do I need to pay attention to when installing?

    The distance between the lifting pump and the toilet bowl should not be longer than 30cm, otherwise the slope is not enough, and the sewage cannot flow smoothly into the equipment;

    When choosing a lifting pump, the sewage discharge capacity must be strong. In addition, the upper discharge height of the sewage lifting pump is limited, up to 7 meters, and the sewage discharge capacity is limited;

    There is a certain amount of noise when the machine is running, but in the basement, it doesn't matter.

  2. Anonymous users2024-01-23

    There are no sewers in the basement, and the water level is lower than the rest of the outside, so it's usually not appropriate to build a restroom unless you use an automatic lift pump to pump the water outside.

Related questions
2 answers2024-09-27

Install a small self-priming pump, add a level controller, when the sewage reaches a certain height, start the sewage pump, pump the water to the sewage pipe.

5 answers2024-09-27

Installing an exhaust fan accelerates the flow of air, and the smell also accelerates. So, you or find someone to carefully check the sealing of the S-bend mouth of the toilet bowl and the sewage outlet on the ground. 2. Seal the small round hole in the inner wall of the lower back of the toilet. >>>More

1 answers2024-09-27

There is no picture, what is the direction, the bathroom or the door of the bathroom?

2 answers2024-09-27

There is no easy way to do this, it is the most troublesome project, the investment is huge and complex. >>>More

4 answers2024-09-27

Find out the reason first. I don't know what kind of drainage pipe your building uses, if it is a cast iron pipe and it is more than ten years old, it is likely that the pipe below the first floor has corroded. >>>More