-
Anonymous users2024-01-24Solid wood flooring has a large shrinkage or swelling rate, and this situation is very easy to occur.
However, from the picture, it is clear that the floor with the largest seam is the only one that shrinks the most, and it can only be said that the moisture content of this floor is higher than that of the others. This shows that the moisture content of this batch of floors is uneven, and some have high moisture content.
There's nothing left to do about this.
Hardwood flooring is such a characteristic that it is suitable for areas where the average annual humidity is relatively stable.
The only thing that has high stability is the red pine flooring of the large garden tree species, but such wood is basically invisible now.
At present, most of the floors on the market are hard wood, and the diameter of the log is very small, the deformation rate is large, and the probability of shrinkage and deformation will be very high if the treatment means are not enough.
-
Anonymous users2024-01-23It needs to be re-spliced, and a carpenter will be found to deal with the floor gap card slot.
-
Anonymous users2024-01-22The situation you mentioned is a common problem with the quality of solid wood flooring, and the only way is to remove the floor and reinstall it again, also known as floor tightening. When you buy solid wood flooring, the merchant should tell you that the floor should be retightened two years after installation. When buying flooring, you should buy "one percent" more, that is, 100 square meters to buy 1 square more in case the floor is tightened after two years.
-
Anonymous users2024-01-21It's the same in my family!! There is no way! Unless you get a new one!!
-
Anonymous users2024-01-20This is not a normal seam. Compared to the seam of the perimeter, it is much larger. It should be a matter of construction.
It's basically impossible to deal with now, and that's all there is to it, unless it's resurfaced.
-
Anonymous users2024-01-19Solid wood flooring is like this, you are glad that there is no bulge, this kind of gap is best not to be treated, do not add filler into it, the only way is to take half of it off and then lay it on, but there may be gaps after a year.
If there are many gaps, you can look for the master, the solid wood floor should be installed to leave expansion joints, the solid wood floor will be hot and cold contraction, and the side is sealed with a seal so you can't see it.
What should I do if there is a large gap in the floor joints at home? Foreigners teach you a trick, come and try it.
What should I do if there is a large gap in the floor joints at home? Foreigners teach you a trick, come and try it.
It's a difficult problem. If you die under the floor, it will be bad, and you can't take it out, and the corpse will rot and smell after a long time. I think the best way is to sacrifice a piece of floor in a corner, make a small hole, sprinkle rat poison on the rat's favorite food, and put it in and out of the hole to lure it out.
Suck twice with a vacuum cleaner first, and then wipe the floor twice with alcohol when wiping the floor, and then use a vacuum cleaner for about 20 minutes, so that it can be repeated for a few days, and the effect is very good, because it is not recommended to use a lot of insecticides indoors,