-
Anonymous users2024-01-24There is a smell when the water supply pipe in the bathroom is discharged, and it will be gone after a while, what is the reason?
Dear, hello, I am happy to serve you, the answer is as follows: the bathroom will stink, first of all, you have to check whether it is a leak at the sewer interface, and the leakage of the pipe mouth will cause a foul smell that is difficult to dissipate. There are two kinds of water leakage on the bathroom wall in the bathroom, one is caused by the leakage of the water pipe, and the other is caused by the leakage of the waterproof layer. The bathroom runs water to see what the reason is, if the water pipe is leaking, close the heating pipe gate, regardless of the friend's use.
There are two kinds of water leakage on the bathroom wall, one is caused by the leakage of the water pipe, and the other is caused by the leakage of the waterproof layer, so when solving the problem of water leakage on the wall of the bathroom, it is necessary to distinguish what causes the leakage. There are three main reasons for the smell of the sewer pipe: 1. The bend did not store water in time, and it evaporated without water for a long time. 2:
The pressure of the sewer system is unbalanced (the ejector vent pipe is blocked), and the bend of the water is "pumped" away when someone else drains the water. 3: The design of the floor drain bend is not good, and the water cannot be stored or the water storage is too small to achieve the sealing effect.
Find out what caused it first, and then think of a solution. If the water in the bathroom is running to see what the reason is, if the water pipe is leaking, it will not work if the main gate of the heating pipe is closed.
-
Anonymous users2024-01-231. The water pressure in your area is relatively low or the water pressure is unstable, and the toilet is not equipped with an anti-siphon device (the water in the toilet tank flows back into the water supply pipe when the water pressure is low).
2. When the pipe is not in place, it is caused by water channeling!
-
Anonymous users2024-01-22Check the drain trap.
-
Anonymous users2024-01-21Is this often the case?
The distance between the toilet sewer pipe and the Rose Pavilion is 330 350 from the wall, so that the distance between the center of the toilet drain and the outside of the toilet can be about 420 430, and at least 400. Nowadays, no matter what kind of toilet, the bend and gas have been formed into a whole, so the ground drain should be more than 600 meters from the wall, which is very good for the toilet.
Generally, the washbasin is about 450mm, the shower is about 1150mm, the dun cloth pool is about 300mm, the toilet is about 250mm, and the distance between the washbasin and the squatting toilet is about 400mm, and the distance between the toilet and the bathtub is about 500mm, but it also needs to be determined according to the specific situation of the bathroom at home, and the above data is for reference only.
The infill wall of the frame structure building is also not allowed to open transverse grooves, because the wall itself also has the problem of self-weight and horizontal load, and the wall is very thin, 200 mm, with extremely low stiffness, and must not be weakened. The wall is very long in the length direction, for example, 4-5 meters, and the stiffness in this direction is very large, so the vertical groove has little effect.
I'd rather walk on the roof than on the ground. The hidden dangers of walking on the ground and walking the wall in the future are too big, and water leakage is a frequent internal problem (after a long time, no one can guarantee 100% no problem). The house with the other wall has to be a frame structure, so you have to pay attention. >>>More
The water pipe installation in the bathroom is generally a water heater m, 60cm from the wall. The washbasin is slotted 30cm from the strength of one meter, and the washbasin socket is one meter and three high, and the slotted from the strength is 35cm. >>>More