The toilet can t be used up after it is used, or the water is kept on until the water tank is full

Generally, the float valve is broken, and there are several possibilities: the valve stem is broken, the water inside the float is ingress, and the rubber gasket of the valve is damaged. As soon as you open the lid, it will be clear at a glance.

Can't be continuously watered:

1. Whether the water inlet angle valve is blocked.

2. If there is no filter device for the water on the toilet, it will also cause blockage from the hose and the two ends from the angle valve to the toilet tank after a long time.

3. The water part on the left side of the figure is damaged. It may be a clogging of limescale, or it may be caused by aging. Buy a brand new one directly for a price of 100-200, and there are dozens of cheap water pieces.

Also, I saw a mineral water bottle in the photo. It is estimated that the landlord wants to save water, and the idea is good, but this method does not work well. First of all, the water bottle can only reduce the total amount of water in the tank, and it is not effective in reducing the amount of water per flush.

This is because it is the amount of water that is set to determine the amount of flushing water.

Water-saving toilets are first of all pipe treatment, followed by water treatment, and many other reasons, water-saving is a series of transformation processes, adding water bottles has a general effect, and some toilets are easy to cause waste of water.

The water inlet is broken. It is advisable to buy a new one.

Or you can open the lid of the tank yourself. Pull up and down which waterstop arm on top of the water inlet with your hand. Let's see where it's stuck. Pull a few more times. If you can't find where it's stuck. Let's get a new one. It's not expensive anyway.

The tank Reed fittings should be rusty. Just buy a new accessory and replace it. It's not worth fixing. It's meant to be a consumable.

It's a problem with the water. If it can't be repaired, replace it with a new one.

Replace the tank accessories with a new one, it should be broken, and it won't take a few dollars.

There should be a problem with the internal structure, and the landlord should find someone to repair it.

I recommend that you buy a new one.

Even if you fix it, it will cost a lot of money.

There is a problem with the tank fittings, and it doesn't cost a few bucks.

The maintenance of smart toilet seats requires a professional master to come to inspect, and there are many reasons for not spraying water.

Factory maintenance Beijing professional maintenance of smart toilets, smart toilet lids, bidets, sales center engaged in smart bathroom: professional smart toilet lid and smart toilet sales, installation, after-sales maintenance, etc., has been more than 10 years. The company operates the sales and installation of various brands of smart toilets and smart toilet covers.

In line with integrity management, people-oriented, pioneering and enterprising, do every job well. Phone 010-51657254

Hello friend, after the toilet is used up, you can't get on the water or the water doesn't stop, the water is until it's full, it may be that the float is broken, see if the float is in the water or it doesn't work, or the float is on the rod There is scale, which causes the water to be full or silted out due to the inflexible movement up and down.

You can use a steel wiping ball to tear off the scale on the pipeline, so that the rod of their float ball is very flexible when moving up and down, so that the water will not be silted out again. Thank you.

That is, the control part of the water and drainage in the toilet tank is broken, just replace one, it is sold online or offline, and you can buy one for dozens of yuan and replace it yourself, which is very simple.

Replace the water valve, about 10 yuan a set.

Or open the lid by yourself and move the float, it should be too much scale and stuck.

Move it up and down to clean up limescale.