Ask a question, the living room tile bedroom floor, the living room should be left with a lot of bri

Updated on Living room 2024-09-29
1 answers
  1. Anonymous users2024-01-24

    Now it is generally the living room tiles, the room floor, as for the color and style, you are afraid that the drop is too big, then you use the floor that sells the most in other stores.

    In fact, your worry is superfluous, everything depends on your own hobbies, if it's me, as long as I like it, I don't care what the gap is.

Related questions
1 answers2024-09-29

Good plan!

Laminate flooring is sometimes of inconsistent quality, and it is advisable to use branded laminate flooring. Bedroom flooring has a health saying. >>>More

1 answers2024-09-29

Here's how:

First of all, the construction elevation line of the ground finishing layer of the living room and bedroom is elastic on the wall, and the elevation line is 50 cm above the ground; >>>More

4 answers2024-09-29

Generally speaking, the living room will use tiles, the bedroom will use wooden floors, the two products have their own shortcomings, the price of ceramic tiles is not cheap, the cost of transportation and installation is higher, the surface of the place where people often walk is easy to grind, and the floor has formaldehyde, but now as long as it is not particularly bad, it can be installed as long as the floor surface is leveled.

1 answers2024-09-29

Use an infrared level to mark two points on each wall of the bedroom and living room to ensure that all the points are at the same horizontal level, and then the ink line springs off the line. The tile is paved with a flat line, and the cement floor of the bedroom is 15mm lower than the ink line (this is limited to a 12 mm thick floor plus a thickness of about 15 mm of mulch, and the bottom of the door leaf is 5 mm higher than the threshold stone to reserve the thickness of the door strip).

1 answers2024-09-29

1. It is possible that the quality of the tiles is poor.

2. There is no seam left during paving, and the problem occurs after heat expansion and cold contraction. >>>More