-
Anonymous users2024-01-24Toilet Tank Problems:1The button on the toilet tank lid does not pop back when pressed, probably due to the rust and aging of the spring inside the toilet button.
You need to replace a spring, or just follow the toilet button. 2.It is very difficult to press the button on the lid of the toilet tank, either because the spring inside the toilet button is rusty and aging, or because the outlet valve is stuck in debris such as sediment.
3.It is difficult to open the outlet valve in the toilet tank, either because the outlet valve is stuck in debris such as sediment, or it may be due to the aging of the outlet valve. 4.
Dial the switch on the side of the toilet tank, the toilet does not flush, if it is a zipper outlet valve, the zipper may be too long or broken, cut it short or change a zipper. 5.Press the button on the side of the toilet, the toilet does not flush, it may be that the toilet wire control line is broken, and the corresponding parts need to be replaced.
6.When the toilet is flushed, the impulse is very weak, first see if there is water in the tank, whether the water level is high enough, if not, it should be the failure of the inlet valve, check whether the inlet pipe is blocked, and check whether the inlet valve float can go up and down freely. Otherwise, there is a possibility that the outlet valve is malfunctioning.
7.The toilet tank inlet pipe is dripping water on the ground, which may be a broken water inlet pipe. 8.
The non-stop flow of water in the toilet bowl may be a malfunction of the outlet valve. You can compare it to see which of the above situations is the right medicine.
-
Anonymous users2024-01-23The button on the toilet is jammed.
You open the toilet lid, and there is a piston push-pull lever corresponding to the button, you can operate it manually, if you can press it, it's okay, and then you press the button on the toilet lid again to see if it's stuck, and if it's stuck, you deal with it according to the situation. For example, add some grease or something, lubricate it.
If the push and pull rod can't be pressed, then the interior has to be repaired.
-
Anonymous users2024-01-221.You first check if the sewer pipe is blocked, it is the sewer pipe and not the pipe of the toilet itself.
2.You can then check the nozzle for impurities, and you can also use wires to make hooks to open the front port.
3.Whether the water tank accessories are faulty, whether the water in the tank is drained every time you flush, or whether it is half drained. There is also a question of whether the sewage pipe of the toilet has scale, wrap a rag with a wire, and stuff it into it to see through.
Analysis of the reasons why the toilet does not drain:
1. Slight blockage of the toilet: Generally, the toilet blockage is caused by toilet paper or sanitary napkins, towel rags, etc., which can be dredged directly by using a pipe dredging machine or simple dredging tools. >>>More
If it is a problem after the new decoration, it is necessary to pay attention to whether some decoration garbage is thrown into the sewage pipe of the toilet during the decoration, so that the sewage pipe is partially blocked, and a little excrement will cause blockage, so it is best to find a professional pipe dredging company to clean it thoroughly, and as long as you do not throw large pieces of garbage into the toilet in the future, there will be no blockage.
First, you only need to close the water inlet valve, open the upper cover of the water tank, remove the blue plastic soft cover on the water feeder (the round pipe and other devices), and then remove the small bolt at the other end of the float, remove the small round black rubber gasket, turn it over and install it again, and finally install the parts as they are, which will generally solve the problem; >>>More
Maybe there is a problem with the adjustment in the tank, find someone who understands to check it.
Fluid pressure relief valves are mainly installed on the equipment or pipelines of the closed system to protect the safety of the system. It is mainly to protect the pressure inside the equipment and piping within the set pressure range.