Urgent The bathroom is the same as the wooden floor outside, what should I do if the water seeps out

Updated on Bathroom 2024-09-09
7 answers
  1. Anonymous users2024-01-24

    Your problem is that the water in the shower is running everywhere, so you should buy a shower room to stop the water from flowing everywhere and also keep the bathroom relatively dry.

    In addition, a floor mat is placed at the door of the bathroom to absorb water (a small amount of dripping water that is usually used), which can effectively block the overflow of water in the bathroom.

    =====================Since you said that there is a bathhouse, it is a problem with the water retaining strip below.

    There are also solutions in this case.

    It is estimated that your bottom is not a stone water retaining strip, or even if it is a stone one, it is not paved for you to find a solution from the stone water retaining strip.

    If not, buy a water retaining strip and lay it on the line, if it is not good to move the bath, lay the stone on the periphery of the bath room.

  2. Anonymous users2024-01-23

    No, you don't have to worry about this, the floor of the bathroom is tilted, as long as the floor drain is not far away then the water will not flow out, you can do a good job of anti-slip measures on the ground Don't worry about water seepage

  3. Anonymous users2024-01-22

    Stick a strip of marble at the bathroom door.

    It doesn't have to be very high. As long as you can get through the water.

  4. Anonymous users2024-01-21

    Stick a small row of tiles at the junction of the bathroom and the wooden floor.

  5. Anonymous users2024-01-20

    Install a doorstone at the door of the bathroom.

  6. Anonymous users2024-01-19

    Add a waterproof strip to the bathroom door.

  7. Anonymous users2024-01-18

    I had a similar problem on the construction site. The main water problem should be at the floor drain, the waterproof under the floor drain is not rolled into the sewer pipe or the drainage is not smooth, between the floor tile surface layer and the waterproof layer due to the capillary siphon effect to absorb water under the wall, because the bathroom wall is generally waterproof and rolled, the water can not run out, it will be sucked up along the wall through the waterproof height reflected on the back of the wall, resulting in the wall or skirting damp and paint. All downstairs without water leakage should not worry about waterproofing.

    It is recommended that the landlord first remove the floor drain, re-process the waterproofing of the floor drain and sewer pipe, and then appropriately reduce the height of the floor drain when reinstalling the floor drain if he can, so as to keep the drainage smooth. In addition, if the floor tile joint is obviously too large and hollow, it should be re-hooked, which can play a certain role. Attention should also be paid to water use and toilet ventilation.

Related questions
1 answers2024-09-09

From the situation you described, it should be caused by a leak in the waterproof of your home. >>>More

2 answers2024-09-09

This is a design error, and the floor of the bathroom should be lower than the outside floor. There are two ways to suggest you try, one is to use glass glue on the outside of the door to glue a composite floor sealing strip, semicircular golden plastic. It doesn't affect access, and it's not ugly. >>>More

3 answers2024-09-09

1. It needs to be installed, one is for waterproofing, and the other is for beauty and there is a clear dividing line. >>>More

1 answers2024-09-09

The blackened part is soaked with water. It is advisable to dispose of it immediately, otherwise the floor will rot.