The solid wood floor has just been paved and there is no sound when stepping on it, and now many pla

1. Don't buy colored flooring: Now the colored floor is flooded with a large number of markets, which is the reason why China's flooring industry is unhealthy, first of all, we fight the price, no profit, and then work the quality of the floor, first of all, they use the B-grade board to fill the A-grade board, or take 1 3 A-grade board to add 2 3 B-grade board, because the B-grade board surface has insect eyes, two-color, white edges, scars need to be repaired with putty and color, and in order to make you not see that this is the repaired board, they are only colored on the board surface, The good ones are also colored in the notches and backs, so that you can't see that this is a coloring board, and the color difference is also small, and the board surface is beautiful, but after the coloring of the floor is paved, after a little time, because the board surface is repaired, cracking, bursting paint and other problems will occur, and if you polish and repair, due to the addition of color and fall off, your floor, have you ever seen the face of Peking Opera?

2. Pay attention to the notch and thickness when buying the floor: these two points are also very critical, we all know that the standard thickness of the floor should be 18mm, but there are a lot of floors on the market, but I am not saying that the poor floor effect will be affected, the key is that the floor is mostly a plate with insufficient thickness or a modified plate along the curve, and most of the curved plates are not dried well or the stress problem is not solved, such a floor is dangerous, its problems will be shown after paving, manifested as arching, corrugated, etc., The length of the notch is another way to cut corners for the manufacturer, because the ground area is calculated by the width and length of the board surface, so the shorter the notch of the manufacturer, the wider its board surface will be, in this way, he virtually reduces the cost, and he does this, causing damage to the consumer, the floor notch is short, it is easy to make a noise, and the floor will squeak when stepped on. The way to avoid the above two deceptive tricks is one:

When buying the floor, first look at it with your eyes, see if the texture of the floor is clear, whether there is a normal color difference, and then let the manufacturer explain whether it is a coloring palette (coloring tablet) on the purchase list, and when you go back to install, the floor will be sawn open, and the side will be coated with water, and see whether the base color of the board is consistent, if the difference is large, it is a coloring plate, about the notch, the national standard is, you can measure it, if you don't measure it, you can put the two boards together, hold one, and the other one will hang at an inclination angle of 45 degrees to see if the other will fall down, if it falls, It is very likely that the length of the notch is insufficient, and in addition, be careful about the floor where the notch is too tight during splicing, because some manufacturers deliberately make the notch very tight in order to keep the board from falling, and the normal notch has a certain gap.

Do an experiment and you will understand the reason for the "crunch" (put two drops of floor essential oil on the paper, and after drying, you will see a hard "shell").

This hard shell dries in the cracks of the floor, and when people walk around, it produces a friction sound.

It's hard to solve. There are no products in the country that remove essential oils from flooring.

This is the normal deformation of solid wood flooring, there is no good way to solve it, this is a common problem of solid wood flooring, as long as solid wood flooring will appear in a similar situation. Multi- or triple-ply solid wood is recommended.

The floor is deformed after the essential oil is beaten. Either the floor is finished and shrinks normally, so the gaps between the floors have changed, there is squeezing, and there are not enough shrinkage joints when paving. This is normal. Solid wood is so troublesome. There are also cracking and paint oxidation problems in the back.